Summary of K 2.110 M

  • Page 1

    K 2.56 m 5.963-407.0 (06/09).

  • Page 2: Safety Alert Symbols

    2 english danger indicates “an imminently hazardous sit- uation which, if not avoided, will result in death or serious injury.” warning indicates “a potentially hazardous situa- tion which, if not avoided, could result in death or injury.” caution indicates “a potentially hazardous situa- tion which...

  • Page 3: Model Overview

    English 3 1 high pressure outlet 2 detergent suction tube with filter 3 on/off switch 4 hose/cord hook 5 retrectable transport handle 6 handle 7 transport handle lock 8 spray wand storage 9 trigger gun holder 10 power cord with ground fault circuit interrupter (gfci) 11 water inlet with garden hose ...

  • Page 4

    4 english warning when using this product basic precau- tions should always be followed, includ- ing the following: read all the instructions before us- ing the product. To reduce the risk of injury, close su- pervision is necessary when a prod- uct is used near children. Know how to stop the produc...

  • Page 5: Save These Instructions !

    English 5 operate this pump with com- ponents rated less than 1600 psi working pressure (in- cluding but not limited to spray guns, hose and hose connections). Before servicing, cleaning or removing any parts, shut off power and relieve pressure. If connection is made to a po- table water system, th...

  • Page 6: Assembly Instructions

    6 english screwdriver, small size (not supplied) for connecting high pressure hose and trigger gun. Î step 1: insert wheels into the side holes of the unit. Î step 2: a pull out the locking slide of the trig- ger gun handle. B insert the small end of the high pres- sure hose into place. C push the l...

  • Page 7

    English 7 Î step 3: connect garden hose to unit’s water inlet. Î step 4: connect garden hose to the cold water source and turn water on completely. Î step 5: plug the ground fault circuit inter- rupter (gfci) into a working outlet. – press “reset” button. – press “test” button. Red indicator on “res...

  • Page 8: Using The Accessories

    8 english warning to avoid serious injury never point spray nozzle at yourself, other per- sons or animals. Always test an inconspicuous area before cleaning with high pressure. The vario power spray wand allows you to adjust the cleaning pressure. To clean at maximum pressure, the wand must be posi...

  • Page 9: Working With Detergents

    English 9 detergents can only be applied at low pressure (min.). Î step 1: install the vario power spray wand. Set the spray wand to the low pres- sure setting (mix). Î step 2: fill a container with kärcher deter- gent. Place the filter end of detergent suction tube into the container. Î step 3: tur...

  • Page 10: Shutting Down & Clean-Up

    10 english Î step 1: release trigger and engage gun safety lock. Î step 2: turn pressure washer to off (0) po- sition. Î step 1: turn the switch to off (0) position and unplug cord from outlet. Î step 2: turn off the water source. Î step 3: press trigger to release water pres- sure. Î step 4: releas...

  • Page 11: Maintenance

    English 11 Î 1: disconnect all water connections. Î 2: turn on the machine for a few seconds, until the water which had remained in the pump exits, turn off immediately. Î 3: do not allow high pressure hose to become kinked. Î 4: store the machine and accesso- ries in a room which does not reach fre...

  • Page 12: Cleaning Tips

    12 english caution before cleaning any surface an in- conspicuous area should be cleaned to test spray pattern and distance for maximum cleaning results. If painted surfaces are peeling or chipping, use extreme caution as pressure washer may remove the loose paint from the surface. When using on sur...

  • Page 13: Cars, Boats & Motorcycles

    English 13 (with or without detergent). Pre-rinse vehicle with fresh water. If using deter- gent, apply to surface at low pressure. For best results, clean one side of vehi- cle at a time and always apply detergent from bottom to top, do not allow deter- gent to dry on surface. If needed, use specia...

  • Page 14: Troubleshooting

    14 english caution disconnect the machine from the power source before making any repair. Troubleshooting symptom cause solution motor will not start on/off switch is in the “off” (o) position. Turn switch to the “on” (i) position tripped gfci plug. Press “reset” button on gfci plug. Power cord is n...

  • Page 15

    English 15 if you encounter any additional difficul- ties not listed, please visit our website. Usa / canada: www.Karcherresidential.Com mexico: www.Karcher.Com.Mx no detergent. Detergent suction tube not properly connected to the machine. Check connection. Detergent is too thick. Dilute detergent, ...