English 2 español 17 français 33 5.961-867.0 01/06 k 2.54 m.
2 english model overview 3 important safety instructions 4 assembly instructions 6 operating instructions 7 using the accessories 8 working with detergents 9 taking a break five minutes or more10 shutting down & clean-up 10 winterizing and long-term storage11 care and maintenance instructions 11 cle...
English 3 1 high pressure outlet 2 detergent suction tube with filter 3 on/off switch 4 hose/cord hook 5 handle 6 collapsable transport handle 7 spray wand storage 8 trigger gun holder 9 power cord with ground fault circuit interrupter (gfci) 10 water inlet with garden hose connector 11 wheels 12 tr...
4 english warning – when using this product basic precautions should always be fol- lowed, including the following: read all the instructions before us- ing the product. To reduce the risk of injury, close su- pervision is necessary when a prod- uct is used near children. Know how to stop the produc...
English 5 in a double-insulated product, two sys- tems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated product, nor should a means for grounding be added to the product. Servicing a dou- ble-insulated product requires extreme care and knowledge o...
6 english screwdriver, small size (not supplied) for connecting high pressure hose and trigger gun. Î step 1: slide the transport handle into place. Î step 2: insert wheels into the side holes of the unit. Î step 3: attach the high pressure hose to the trigger gun. A pull out the locking slide from ...
English 7 Î step 1: connect the high pressure hose to the unit’s high pressure outlet. Î step 2: insert the spray wand of your choice into the trigger gun. Press in against the spring tension and twist into locked position. Î step 3: connect garden hose to unit’s water inlet. Î step 4: connect garde...
8 english warning to avoid serious injury never point spray nozzle at yourself, other per- sons or animals. The vario power spray wand allows you to adjust the cleaning pressure. To clean at maximum pressure, the wand must be positioned to the high pressure setting (max). For lower pressure turn t...
English 9 detergents can only be applied at low pressure (min.). Î step 1: install the vario power spray wand. Set the spray wand to the low pres- sure setting (min.). Î step 2: fill a container with kärcher deter- gent. Place the filter end of detergent suction tube into the container. Î step 3: tu...
10 english Î step 1: release trigger and engage gun safety lock. Î step 2: turn pressure washer to off (o) position. Î step 1: turn the switch to off (0) position and unplug cord from outlet. Î step 2: turn off the water source. Î step 3: press trigger to release water pres- sure. Î step 4: disconne...
English 11 Î 1: disconnect all water connections. Î 2: turn on the machine for a few seconds, until the water which had remained in the pump exits, turn off immediately. Î 3: do not allow high pressure hose to become kinked. Î 4: store the machine and accesso- ries in a room which does not reach fre...
12 english (with or without detergent). Pre-rinse deck and surrounding area with fresh water. If using kärcher deck wash, ap- ply to surface at low pressure. For best results, limit your work area to smaller sections of approximately 25 square feet. Allow deck wash to remain on sur- face 1-3 minutes...
English 13 re. Allow pressure wash to remain on surface 1-3 minutes. Do not allow deter- gent to dry on surface. Rinse at high pressure keeping the spray nozzle ap- proximately 3-6 inches from the cle- aning surface. For removing extremely stubborn dirt, it may be necessary to move the spray nozzle ...
14 english sections for variable length. 66" fully as- sembled. Fits most karcher pressure washers up to 2300 psi. (bayonet) part no. 2.640-746.0 for more effortless cleaning of all smooth surfaces (painted, glass and plastic) try karcher's rotating wash brush. Use it on your automobile, house sidin...
English 15 caution disconnect the machine from the power source before making any repair. Troubleshooting symptom cause solution motor will not start on/off switch is in the “off” (o) position. Turn switch to the “on” (i) position tripped gfci plug. Press “reset” button on gfci plug. Power cord is n...
16 english if you encounter any additional difficul- ties not listed, please call 1-800-537-4129 for help or visit our website: www.Karcher-usa.Com/home call: 1-800-465-4980 for help or visit our website: www.Karcher-canada.Com call: 01-800-024-13-13 for help or visit our website: www.Karcher.Com.Mx...
