Kuppersbusch EKV 6500 Instruction Manual - page 11
then push the PUSH symbol fully in until it clicks into place.
N.B.! If the infuser is difficult to insert, you must first adapt it to
the right dimensions by pressing it forcefully from the bottom and top as
shown in the figure.
7. Once inserted, make sure the two red buttons have snapped out.
8. Replace the drip tray (A11) and grounds container.
9. Close the service door (A2).
Cleaning the milk container
Important! Always clean the tubes inside the milk container (B)
when you prepare milk. If there is still milk in the container, do not leave it
out of the refrigerator for longer than strictly necessary. Clean the contai-
ner each time you prepare milk as described in Note 3 in the section "Ma-
king cappuccino".
1. Turn the milk container lid clockwise then remove it.
2. Remove the milk spout and intake tube.
3. Remove the frothed milk regulator by pul-
ling it outwards.
4. Wash all the components thoroughly with
hot water and mild washing-up liquid.
Make sure there are no milk residues left
inside the holes and the groove on the fine
end of the frothed milk regulator.
5. Check that the intake tube and spout are
not clogged with milk residues.
6. Replace the frothed milk regulator, milk
spout and intake tube.
7. Replace the milk container lid.
CHANGING AND SETTING
MENU PARAMETERS
When the appliance is ready, you can use the internal menu to modify the
following parameters and functions:
•
Choose language
•
Shut-off time
•
Set clock
•
Start time
•
Auto-start
•
Temperature
•
Water hardness
•
Program coffee
•
Program cappuccino
•
Program water
•
Descale
•
Reset to default
•
Statistics
•
Install filter
•
Reset filter
•
Buzzer
Setting the language
To change the language on the display, proceed as follows:
•
Press the M icon (C10) to enter the menu. "CHOOSE LANGUAGE" is di-
splayed.
•
Press the OK icon (C12).
•
Press the icons (C8) and (C11) until the required language is di-
splayed.
•
Press the OK icon (C12) to confirm.
•
Press the ESC icon (C9) to exit the menu.
N.B.! If you choose the wrong language, you can access the menu di-
rectly to modify the parameter.
•
Press the M icon button (C10) for at least 7 seconds until the appliance
displays the various languages.
•
Choose the required language as described in the section "Using the
appliance for the first time".
Changing the length of time the appliance remains
on
The appliance is set by default to go off automatically 30 minutes after the
last coffee has been made. To change this interval (max. 120 min), proceed
as follows:
•
Press the M icon (C10) to enter the menu and then the icons (C8)
and (C11) until "SHUT-OFF TIME" is displayed.
•
Press the OK icon (C12) to confirm.
•
Press the icons (C8) and (C11) to set the time after which the ap-
pliance will go off (after 1/2 hour, 1 hour, 2 hours).
•
Press the OK icon (C12) to confirm.
•
Press the ESC icon (C9) to exit.
Setting the clock
•
Press the M icon (C10) to enter the menu and then the icons (C8)
and (C11) until "SET CLOCK" is displayed.
•
Press the OK icon (C12).
•
Use the icons (C8) and (C11) to set the hour, then press the OK
icon (C12) to confirm.
•
Use the icons (C8) and (C11) to set the minutes, then press the
OK icon (C12) to confirm.
•
Press the ESC icon (C9) to exit the menu.
Setting auto-start time
This function programmes the time the machine will come on automati-
cally.
•
Make sure the clock on the appliance has been set.
•
Press the M icon (C10) to enter the menu and then the icons (C8)
and (C11) until "START TIME" is displayed.
•
Press the OK icon (C12).
•
Use the icons (C8) and (C11) to set the auto-start time, then press
the OK icon (B9) to confirm.
•
Use the icons (C8) and (C11) to set the minutes, then press the
OK icon (C12) to confirm.
•
Press the icons (C8) and (C11) to activate the auto-start function
until "AUTO START" is displayed.
•
Press the OK icon (C12) to confirm. The symbol appears on the
display.
•
Press the ESC icon (C9) to exit the menu.
Spout
Milk intake tube
Groove
Frothed
milk
regulator
Hole
Hole
15