Kuppersbusch EKV 6500 Instruction Manual - page 7
USING THE APPLIANCE FOR THE FIRST
TIME
•
Coffee has been used to factory test the appliance and it is therefore
completely normal for there to be traces of coffee in the mill.
The machine is, however, guaranteed to be new.
•
You should customise water hardness as soon as possible following the
instructions in the "Setting water hardness" section.
1. Connect the appliance to the mains electricity supply and press the
main switch (A19).
2.
Set the required language.
To set the language, use the icons (C8 e C11) to choose the re-
quired language (fig. 2). When the message "PRESS OK TO CHOOSE
ENGLISH" is displayed, press the OK icon (C12) (fig. 3) for 3 seconds
until "ENGLISH INSTALLED" is displayed. If you set the wrong language,
follow the instructions in the "Setting the language" section. If your lan-
guage is not available, select one from those displayed. The instruc-
tions refer to the English version. Then follow the instructions
displayed:
Then follow the instructions displayed:
3. After 5 seconds, the appliance displays "FILL TANK". Extract the water
tank (fig. 4), rinse and fill with fresh water without exceeding the MAX
line. Replace and push as far as it will go. A water softener filter can
be installed in the tank.
4. Place a cup under the hot water spout (fig. 5). (If the hot water spout
is not inserted, the appliance displays "INSERT WATER SPOUT". Attach
it as shown in figure 4. Press the OK icon (C12) (fig. 3) and after a few
seconds a little water comes out of the spout. (Delivery stops automa-
tically).
5. The machine now displays "TURNING OFF... PLEASE WAIT" and goes
off.
6. Extract the appliance by pulling it out using the handles (fig. 7). Open
the lid and fill the container with coffee beans, then close the lid and
push the appliance in.
The coffee maker is now ready for normal use.
Important! Never introduce pre-ground coffee, freeze dried coffee,
caramelised beans or anything else which could damage the appliance.
N.B.! When using the appliance for the first time, you need to make
4-5 cups of coffee and 4-5 cappuccinos before the appliance gives sati-
sfactory results.
N.B.! Each time you turn the coffee maker on by the main switch
(A19), it performs a SELF-DIAGNOSIS cycle and then goes off. To turn it on
again, press the On/stand-by button (A21) (fig. 1)
Installing the filter
Some models are fitted with a water softener filter to improve the quality of
the water used and extend the working life of the appliance.
To install, proceed as follows:
1. Remove the filter (B9) from the packaging;
2. Slide the date indicator pointer (see fig. 30) until the months of use are
displayed.
N.B.! The filter lasts about two months if the appliance is used nor-
mally. If the coffee maker is left unused with the filter installed, it will
last a maximum of three weeks.
3. Fill the tank with a little water up to the level shown in the figure:
4. Insert the filter in the water tank and press it until it touches the bottom
of the tank (see fig. 30);
5. Fill the water tank and place it in the coffee maker, then insert the hot
water spout (B7) (fig. 5).
6. Position a container under the spout (fig. 6) (min. capacity: 100 ml).
N.B.! When you install the filter, you must notify the appliance of its
presence.
7. Press the M icon (C10) (fig. 15) to enter the menu
.
8. Press the icons (C8) and (C11) until "INSTALL FILTER" is displa-
yed
9. Press the OK icon (C11).
10. The message "INSTALL FILTER PLEASE CONFIRM" is displayed.
11. Press the OK icon (C12) to confirm the selection (or ESC (B9) to can-
cel). "HOT WATER PRESS OK" is displayed.
12. Press the OK icon (C12) again. The appliance begins delivering hot
water and the message "PLEASE WAIT... " is displayed.
When delivery stops, the appliance automatically displays the basic
modes set again.
N.B.! The appliance may request the operation to be repeated a num-
ber of times until the air is completely elminated from the hydraulic circuit.
Replacing the filter ("Filter reset")
When "REPLACE FILTER" is displayed or after 2 months of use (see date in-
dicator), the filter must be replaced:
1. Remove the exhausted filter.
2. Remove the new filter from the packaging.
3. Slide the pointer of the date indicator (see fig. 30) until the months of
use are displayed (the filter lasts about 2 months);
4. Insert the filter in the water tank and press it until it touches the bottom
of the tank (see fig. 30);
5. Fill the water tank and place it in the coffee maker, then insert the hot
water spout (B7) (fig. 6).
6. Position a container under the spout (min. capacity: 100 ml).
7. Press the M icon (C10) to enter the menu.
8. Press the icons (C8) and (C11) until "FILTER RESET" is displa-
yed;
9. Press the OK icon (C12).
10. The message "FILTER RESET CONFIRM" is displayed.
11. Press the OK icon (C12) to confirm the selection (or ESC (C9) to can-
cel). "HOT WATER PRESS OK" is displayed.
12. Press the OK icon (C12) again. The appliance begins delivering hot
water and the message "PLEASE WAIT..." is displayed.
When delivery stops, the appliance automatically displays the basic
modes set again.
Removing the filter
To use the appliance without a filter, you must remove it and notify the ap-
pliance of its removal as follows:
1. Press the M icon (C10) to enter the menu.
2. Press the icons (C8) and (C11) until "INSTALL FILTER*" is displayed.
3. Press the OK icon (C12). The message "INSTALL FILTER* CONFIRM" is di-
splayed.
4. Press the M icon (C10)
5. The message "INSTALL FILTER" is displayed.
5. Press the M icon (C10) or ESC icon (B9) to exit the menu.
The appliance automatically displays the basic modes set again.
N.B.! Use the filters recommended by the manufacturer only. Use of
unsuitable filters could damage the appliance.
TURNING ON AND HEATING UP
Each time the appliance is turned on, it performs an automatic preheat and
rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.
Danger of burns! During rinsing, a little hot water flows from the
coffee spouts.
To turn the appliance on, press the On/stand-by button (A21) (fig. 1). The
11