LabStyle Dario User Manual - page 28
Chapter 3 - Checking Your Dario™ Glucose Meter
Checking Your Glucose Meter With Dario™ Control solutions
24
When the meter detects that the solution was applied, the “Measuring...” message
appears. The orange rotating in the circle indicates that the test is in progress.
8. The test result appears on the screen after six (6)seconds. Read your result and
look at the test strip .
The glucose test result is automatically saved to memory. The result appears on the
screen and is automatically saved to memory.
It is possible to delete this control test from memory, if desired.
For more information, refer to the Dario™ Application User Guide at
www.mydario.com
.
9. When the test is done, remove the test strip.
10. Compare the results on the meter with the values displayed on the test strip
cartridge.
11. If the results are:
y
within the acceptable range, then your meter is ready for use.
y
outside of the acceptable range, perform the test again. If the problem recurs,
contact customer support at
www.mydario.com
.
12. Disconnect the meter from your smart mobile device.
13. Wipe the tip of the control solution container clean and tightly seal the container.
The Dario™ Glucose Control Solution ranges printed on the test strip
cartridge label are intended for the Dario™ test strip cartridge only.