LaCie 12big Rack Fibre 8 Quick Install Manual - Cabling Multiple Enclosures
LaCie 12big Rack Fibre 8
Setup and Cabling
Quick Install Guide
page 8
Figure 14: LaCie 12big Rack Fibre 8 expansion enclosure: Dual Host,
Dual Controller Cabling with a Switch
Figure 15: Connecting the AC Power Cords
Figure 8: Simplex: Single Host (Single HBA)
Cabling Multiple Enclosures
4.3.
Figures 13 and 14 depict the multiple enclosure supported
cabling configurations. Locate the figure that depicts your
configuration and cable it accordingly.
Connecting the Power Cords
4.4.
and Powering On the System
Connect the power cords to the PCMs. Move the bale
1.
out of the way, insert the cord and place the bale over
and onto the cord. Repeat for the other PCMs.
Ensure the ON/OFF switch is in the OFF position.
Attach the power cords to the Power Distribution Units,
2.
ensure they use separate power sources.
Power on the storage system by placing each of the
3.
PCM ON/OFF switches to the ON position.
For more details refer to the LaCie 12big Rack Fibre 8 User
Guide, as well as the StorView Storage Management Software
RAID Module User Guide and the VT-100 RAID Configuration
Utility User Guide.
Figure 13: LaCie 12big Rack Fibre 8 expansion enclosure: Dual Hosts,
Dual Controller Cabling