LaCie 12big Rack Fibre 8 Quick Install Manual - Setup and Cabling
LaCie 12big Rack Fibre 8
Rack Installation/Setup and Cabling
Quick Install Guide
page 6
Front attach points only. Remove this nut
for tapped hole rack installations.
Figure 5: Mounting the Enclosure into a Rack
Figure 4: Securing Brackets to Rack - Left Hand Assembly Shown
Figure 6: Installing the SFP Module
Assemble the rack brackets to the rack posts as follows.
3.
The bracketsare universal and will fit either side.
(See Figure 4.)
a. Locate the guide pin at the rear of each bracket
and insert that pin into a rear rack post hole. Attach
the bracket to the rear rack post using the washers and
screws supplied. The screws should be left loose.
b. Extend the rail to fit between the rack posts.
c. Attach the bracket to the front rack post using the
washers and screws supplied. The screws should be
left loose.
d. Tighten the two clamping screws located along the
inside of the rear section of the rack bracket.
Mount the enclosure in the rack as follows:
4.
(See Figure 5)
a. Using an assistant, lift the enclosure aligning it with
the rack rails and carefully insert the chassis slides into
the rack rails.
b. Push the enclosure completely into the rack cabinet.
c. Tighten the rear rack bracket mounting screws,
that were previously left loose.
d. Withdraw the enclosure until it reaches the hard stops
(approximately 400 mm (15.75 inches)).
e. Tighten the front rack bracket mounting screws, that
were previously left loose.
f. Push the enclosure completely into the rack cabinet
and attach to the front of the rack using the captive
Setup and Cabling
4.
Installing the SFP Modules
4.1.
Insert the SFP transceiver module into the SFP cage and
1.
push to seat it. Ensure the ejector is positioned to its
stored location.
Install the remaining SFP transceiver modules into the
2.
remaining open SFP cages as desired.
Install the fiber channel cables as indicated in the
3.
cabling diagrams listed in section 4.2.
fasteners on the front flanges (located just outside
of the handles).
Re-install the plug-in modules removed in preparation
5.
for the installation, then continue with section 4.1, 4.2,
4.3 and 4.4 to complete the installation.