Lantech IES-2208CA User manual - page 110
103
Format:[yyyymmdd-
hh:mm]
function is inactive,
this command can
’t be
applied.
Parameter format:
[yyyymmdd-hh:mm]
switch(config)# sntp daylight-
period 20120808-01:01
20120809-01:01
ntp daylight-offset
[Minute]
G
Set offset of daylight
saving time, if SNTP
function is inactive,
this command can
’t be
applied.
switch>enable
switch#configure
switch(config)#sntp daylight-
offset 60
show sntp
P
Show SNTP
information
switch>enable
switch#show sntp
show sntp timezone
P
Show index number of
time zone list
switch>enable
switch#show sntp timezone
no sntp
G
Disable SNTP function switch>enable
switch#configure
switch(config)#no sntp
no sntp daylight
G
Disable daylight
saving time
switch>enable
switch#configure
switch(config)#no sntp daylight
LLDP Commands Set
Netstar Commands
Level Description
Example
lldp enable
G
Enable LLDP function switch>enable
switch#configure
switch(config)# lldp enable
lldp interval
[TIME sec]
G
Configure LLDP
interval
switch>enable
switch#configure
switch(config)#lldp interval 1800
lldp synctime
[enable|disable]
G
Enable/disable LLDP
sync time
switch>enable
switch#configure
switch(config)#lldp synctime
enable