Lantech IES-2208CA User manual - page 131
124
| authorize]
configuration
command to set the
state of the selected
port.
switch(config)#interface
fastethernet 3
switch(config-if)#8021x portstate
authorize
show 8021x
P Displays a summary of
the 802.1x properties
and also the port
sates.
switch>enable
switch#show 8021x
no 8021x
G Disable 802.1x
function
switch>enable
switch#configure
switch(config)#no 8021x
Fault Alarm Commands Set
Netstar Commands
Level Description
Example
fault-relay power
[number]
[enable/disable]
G
Configure Relay Alarm
for Power Failure
switch>enable
switch#configure
switch(config)#fault-relay power 1
enable
fault-relay
[enable/disable]
I
Configure Relay Alarm
for Port Link
Down/Broken
switch>enable
switch#configure
switch(config)#interface
fastEthernet 1
switch(config-if)#fault-relay
enable
show fault-relay
P
Show Fault Relay
Alarm setting
switch>enable
switch#show fault-relay
no fault-relay
G
Disable Fault Relay
Alarm function
switch>enable
switch#configure
switch(config)#no fault-relay
System Warning Commands Set
Netstar Commands
Level Description
Example
systemlog mode
[client|server|both]
G
Specified the log
mode
switch>enable
switch#configure
switch(config)# syslog mode both