Lantech IES-2208CA User manual - page 56
49
6.12 Port - Configuration
In Port control you can configure the settings of each port to control the connection
parameters, and the status of each port is listed beneath.
Port No.: The port number which you want to be configured.
State: Current port state. The port can be set to disable or enable mode. If the port
state is set as
‘Disable’, it will not receive or transmit any packet..
Speed/Diplex: It can be set as auto or set speed and negotiated way manually.
Flow Control: Whether or not the receiving node sends feedback to the sending
node is determined by this item. When enabled, once the device exceeds the input
data rate of another device, the receiving device will send a PAUSE frame which
halts the transmission of the sender for a specified period of time. When disabled,
the receiving device will drop the packet if too much to process.
Alies: Add description of each port to let the manager know the connected device of
each port, it will be showed by NMS utility.
Click
Apply
to have the configuration take effect.