Lantech IES-2208CA User manual - page 116
109
only
limit frame type to
“only accept broadcast
frame”
switch#configure
switch(config)#interface
fastEthernet 2
switch(config-if)# ratelimit type
broadcast-only
ratelimit in
[kbps]
I
Set interface input
bandwidth. zero
means no limit.
switch>enable
switch#configure
switch(config)#interface
fastEthernet 2
switch(config-if)# ratelimit in 160
ratelimit out
[kbps]
I
Set interface output
bandwidth. Rate
Range is from 100
kbps to 102400 kbps
or to 256000 kbps for
giga ports,
and zero means no
limit.
switch>enable
switch#configure
switch(config)#interface
fastEthernet 2
switch(config-if)# ratelimit out 160
show ratelimit
I
Show interfaces
bandwidth control
switch>enable
switch#configure
switch(config)#interface
fastEthernet 2
switch(config-if)#show ratelimit
Trunk Commands Set
Netstar Commands
Level Description
Example
aggregator priority
[1~65535]
G
Set port group system
priority
switch>enable
switch#configure
switch(config)#aggregator priority
22
aggregator group
[GroupID] [Port-list]
lacp
workp
G
Assign a trunk group
with LACP active.
[GroupID] :1~3
[Port-list]:Member port
switch>enable
switch#configure
switch(config)#aggregator group
1 1-4 lacp workp 2