[ adjustable bases ] adjustablebases.Com © 2012 leggett & platt adjustable bed group, a division of leggett & platt, incorporated made in the usa nationwide customer service toll free: (800) 888-3078 99301294 edr11908 3/12 owners manual [ adjustable bases ].
Designer series ™ 99301294 26 repairs to or replacement of an adjustable base or its components under the terms of this limited warranty will apply to the original warranty period and will not serve to extend such period. The decision to repair or to replace defective parts under this warranty shall...
Designer series ™ 99301294 4 important information read the following information carefully before using this product electrical rating electrical components are rated for 110/120 voltage, 60hz, 3.9 amp. Electrical grounding this product is equipped with a polarized or grounded electrical power cord...
Designer series ™ 99301294 24 troubleshooting in the event the adjustable base fails to operate, investigate the symptoms and possible solutions provided in the chart below: symptom solution • verify power cord is plugged into a working, grounded electrical outlet. A grounded, electrical surge prote...
Designer series ™ 99301294 6 acoustics lifting/lowering mechanisms the lift/lower feature will emit a minimal humming sound during operation. This is normal. During operation, the lift arm wheels make contact with the platform support of the base. This applies slight tension on the moving components...
Designer series ™ 99301294 22 mr2t8-tvzg remote control programming (2 remote controls - 2 bases) program two remotes to operate two bases - your adjustable base will be equipped with one of the following: (a) a dc motor with a power down box, (b) an ac j box, (c) a dc motor without a power down box...
Designer series ™ 99301294 8 installation step 2 carefully lift the adjustable base out of the shipping carton and position it on its side on a clean surface. While holding it steady and secure, screw the legs into the tapped inserts at each corner of the base (figure 2). Note: do not let base rest ...
Designer series ™ 99301294 20 mr2t8-tvzg remote control programming (2 remote controls - 1 base) operate only one (1) remote control at a time. Operating two (2) remote controls at the same time will momentarily block both rf signals and prevent both controls from functioning. Note step 3 repeat ste...
Designer series ™ 99301294 10 step 5 plug electrical power cord into a working, grounded electrical outlet. Note: an electrical surge protection device is recommended (not included). Step 6 install batteries in remote control. Briefl y activate all functions of the base with the remote control to ver...
Designer series ™ 99301294 18 ac j box / dc motor without power down box programming procedure when programming the remote control, unplug the adjustable base electrical power cord. Wait 30 seconds, then plug the cord back into the power source. This process automatically sets the bed to the program...
Designer series ™ 99301294 12 3 inches max . Figure 6: headboard cross member location must not exceed 3 inches (76.2mm) from the top of the mattress. Headboard bracket installation installation failure to follow headboard bracket installation instructions may cause headboard bracket interference wi...
Designer series ™ 99301294 16 installation h. Measure the center-to-center distance between the mounting slots of the headboard bracket fl anges (figure 11). I. If bracket fl ange adjustment is required to accept the headboard, remove the 1 inch long hex head bolts and move fl anges side-to-side for th...
Designer series ™ 99301294 14 c. Locate (2) slotted holes in base frame at one corner of head end of base. Place the headboard bracket weldment underneath base frame and against the head end of the base, positioning the bracket weldment so the carriage bolt appears through the innermost slotted hole...
