Leggett & Platt Designer Series Owner's Manual - page 13
Designer Series
™
99301294
16
INSTALLATION
h. Measure the center-to-center distance between the mounting slots of the
headboard bracket fl anges (FIGURE 11).
i. If bracket fl ange adjustment is required to accept the headboard, remove the
1 inch long hex head bolts and move fl anges side-to-side for the adjustment
(FIGURE 11). Reinstall bolts. Tighten all headboard mounting bolts.
j. Firmly tighten all bolts of both headboard bracket assemblies.
k. Install headboard.
Typical Designer Series™
adjustable base installation is now complete.
STEP 10
Install mattress on adjustable base.
MEASURE FLANGE SLOTS
CENTER-TO-CENTER TO CHECK
HEADBOARD HOLE LOCATION
REMOVE 1 INCH LONG HEX HEAD BOLTS AND RELOCATE
FLANGES TO ACHIEVE CENTER-TO-CENTER DISTANCE
REQUIRED FOR HEADBOARD MOUNTING HOLES
FIGURE 11: Headboard bracket measurement and adjustment to accept headboard.
Designer Series
™
99301294
13
STEP 9 (Optional - if headboard is to be attached)
Install headboard brackets to the adjustable base frame as follows:
a. Using the remote control, raise the head section of the base as far as it
will articulate to gain access to the adjustable base frame.
b. Insert a 1/2” carriage bolt into a headboard bracket weldment
(FIGURE 7).
INSTALLATION
FIGURE 7: Headboard bracket weldment.
1/2” CARRIAGE
BOLT
HEADBOARD
BRACKET
WELDMENT