Leggett & Platt Designer Series Owner's Manual - page 11
Designer Series
™
99301294
18
AC J BOX / DC MOTOR without power down box PROGRAMMING PROCEDURE
When programming the remote control, unplug
the adjustable base electrical power cord. Wait
30 seconds, then plug the cord back into the
power source. This process automatically sets
the bed to the program mode for 90 seconds.
For convenience, use this procedure in lieu of
pressing the learn button (located on the AC
J Box, mounted to the underside of the base
frame).
Note that this programming feature is only
applicable to bases without a power down box.
Power down equipped adjustable bases require
use of the learn button on the power down box
when programming the remote control.
In case of a power outage, press and hold the
learn button on the power down box to lower
the base to the fl at position (FIGURE 12).
This function is only for lowering the base and
will not operate the base to any other position.
The two (2) 9 volt batteries should be replaced
after this function is used.
In the event the power down feature does not
work, check to make sure the two (2) 9 volt
batteries are good.
The power down box is factory wired to the motor,
but the box itself is mobile and can be placed
anywhere under the adjustable base on the fl oor.
Position the power down box near your remote
control when programming for best results.
POWER DOWN BOX OPERATION
POWER
DOWN BOX
LEARN
BUTTON
FIGURE 12: Power down box learn button.
For adjustable bases equipped with AC J box or DC motor only—no power down box.
POWER DOWN BOX BATTERY INSTALLATION
PRESS IN (SLIGHTLY) AND
PUSH DOW TO REMOVE
BATTERY COMPARTMENT
DOOR
BATTERY ORIENTATION IS
INDICATED INSIDE BATTERY
COMPARTMENT
DOOR INSTALLATION:
PRESS COMPARTMENT
DOOR AGAINST THE
BATTERY ENDS, SLIDE
DOOR UP AND IN TO
ENGAGE THE DOOR
TABS
TABS
STEP 1
STEP 2
Designer Series
™
99301294
11
NOTE: If base is to be set up without a headboard,
basic installation is now complete. If headboard is to be
installed, proceed to Headboard Bracket Installation.
b. Place mattress retainer ends into grommeted holes in top surface of
adjustable bed base (FIGURES 4 and 5). Press down until horizontal
retainer section is fl ush against bed base.
INSTALLATION
FIGURE 5: Mattress retainer installation.
MATTRESS
RETAINER
FOOT END OF BASE