Leggett & Platt Designer Series Owner's Manual - page 14
Designer Series
™
99301294
14
c. Locate (2) slotted holes in base frame at one corner of head
end of base. Place the headboard bracket weldment underneath
base frame and against the head end of the base, positioning
the bracket weldment so the carriage bolt appears through the
innermost slotted hole in the base frame (FIGURE 8). Place hex
nut on 1/2” long carriage bolt to attach bracket weldment to base
frame. Loosely tighten to allow adjustment for headboard hole
alignment. Place second 1/2” long carriage bolt in remaining slot
and secure using hex nut. Loosely tighten to allow adjustment for
headboard hole alignment.
INSTALLATION
FIGURE 8: Headboard bracket weldment installation.
HEADBOARD
BRACKET
WELDMENT
HEAD END
OF BASE
FRAME
SLOTS
1/2 INCH LONG
CARRIAGE BOLT
Designer Series
™
99301294
15
INSTALLATION
d. Place headboard fl ange weldment against headboard bracket
weldment. Install (2) 1” long hex bolts through slots in headboard
bracket weldment and holes in headboard fl ange weldment
(FIGURE 9). Secure using (2) hex nuts. Loosely tighten to allow
adjustment for headboard hole alignment.
e. Repeat procedure to attach the other headboard bracket assembly
(FIGURE 10).
FIGURE 10: Headboard bracket installed to one corner of adjustable base.
USE (2) 1 INCH LONG HEX HEAD
BOLTS TO ATTACH FLANGE
WELDMENT TO BRACKET WELDMENT
SLIDE BRACKET
ASSEMBLIES IN OR
OUT TO ACHIEVE
POSITION
HEADBOARD
BRACKET
WELDMENT
SLOTS
1 INCH LONG
HEX HEAD BOLT
HEADBOARD
FLANGE
WELDMENT
FIGURE 9: Headboard fl ange weldment installation.
SLIDE BRACKET
ASSEMBLIES IN OR
OUT TO ACHIEVE
POSITION