Leggett & Platt Designer Series Owner's Manual - page 8
Designer Series
™
99301294
8
INSTALLATION
STEP 2
Carefully lift the adjustable base out of the shipping
carton and position it on its side on a clean surface.
While holding it steady and secure, screw the legs
into the tapped inserts at each corner of the base
(FIGURE 2). NOTE: DO NOT LET BASE REST ON
LEGS!
FIGURE 2: Leg installation.
TAPPED INSERTS
FOR LEGS
LEGS INSTALLED
DO NOT ATTEMPT TO SCREW
LEGS INTO ANY OTHER INSERTS.
THIS WILL DAMAGE PRODUCT.
CAUTION
AT LEAST TWO PEOPLE ARE
RECOMMENDED FOR HANDLING AND
MOVING ADJUSTABLE BASE.
Designer Series
™
99301294
21
MR2T8-TVZG REMOTE CONTROL PROGRAMMING (1 remote control - 2 bases)
STEP 3
Repeat Step 1 and Step 2 with base 2.
One remote control is now programmed to
operate two bases.
FOOT UP
BUTTON
TV POSITION
BUTTON
TRANSMISSION
INDICATOR LIGHT
FIGURE 14
BASE 1
BASE 2
FIGURE 13: Power down box, AC J box and DC motor.
LEARN
BUTTON
POWER
DOWN BOX
AC J BOX
POWER DOWN
BOX (NOT
MOUNTED TO
BASE FRAME)
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
LEARN
BUTTON
DC MOTOR-NO
POWER DOWN
BOX
DC MOTOR
(MOUNTED TO
BOTTOM SIDE OF
BASE FRAME)
A
B
C
Program One Remote to Operate Two Bases - your adjustable
base will be equipped with one of the following: (A) a DC motor
with a power down box, (B) an AC J box, (C) a DC motor without
a power down box (FIGURE 13).
STEP 1
(A) DC motor with a power down box: press
the learn button on the power down box for 1
second.
(B or C) AC Jbox or DC motor without power
down box: unplug the adjustable base electrical
power cord. Wait 30 seconds, then plug the
cord back into the power source.
STEP 2
On the remote control, simultaneously press
and hold the foot up and tv position buttons
(FIGURE 14). The transmission indicator
light will fl ash slowly and then fl ash rapidly to
indicate programming mode. Continue to hold
for 5 seconds and then release the buttons.