Leggett & Platt Designer Series Owner's Manual - page 10
Designer Series
™
99301294
10
STEP 5
Plug electrical power cord into a working, grounded electrical outlet.
Note: an electrical surge protection device is recommended (not included).
STEP 6
Install batteries in remote control. Briefl y activate all functions of the base
with the remote control to verify all features are in working order. If base
does not operate, refer to the Troubleshooting section of this manual.
STEP 7
Return base to the level position.
STEP 8
Install mattress retainer at the foot end of the adjustable base as follows:
a. Locate grommeted holes at foot of base (FIGURE 4).
INSTALLATION
FIGURE 4: Grommeted hole locations.
GROMMETED
HOLES
FOOT END OF BASE
Designer Series
™
99301294
19
MR2T8-TVZG REMOTE CONTROL PROGRAMMING
(1 remote control - 1 base)
Program One Remote to Operate One Base - your adjustable
base will be equipped with one of the following: (A) a DC motor
with a power down box, (B) an AC J box, (C) a DC motor without
a power down box (FIGURE 13).
STEP 1
(A) DC motor with a power down box: press
the learn button on the power down box for 1
second.
(B or C) AC Jbox or DC motor without power
down box: unplug the adjustable base electrical
power cord. Wait 30 seconds, then plug the
cord back into the power source.
STEP 2
On the remote control, simultaneously press
and hold the foot up and tv position buttons
(FIGURE 14). The transmission indicator
light will fl ash slowly and then fl ash rapidly to
indicate programming mode. Continue to hold
for 5 seconds and then release the buttons.
One remote control is now programmed to
operate one base.
FOOT UP
BUTTON
TV POSITION
BUTTON
TRANSMISSION
INDICATOR LIGHT
FIGURE 14
FIGURE 13: Power down box, AC J box and DC motor.
LEARN
BUTTON
POWER
DOWN BOX
AC J BOX
POWER DOWN
BOX (NOT
MOUNTED TO
BASE FRAME)
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
LEARN
BUTTON
DC MOTOR-NO
POWER DOWN
BOX
DC MOTOR
(MOUNTED TO
BOTTOM SIDE OF
BASE FRAME)
A
B
C