Leggett & Platt Designer Series Owner's Manual - page 7
Designer Series
™
99301294
22
MR2T8-TVZG REMOTE CONTROL PROGRAMMING (2 remote controls - 2 bases)
Program Two Remotes to Operate Two Bases - your
adjustable base will be equipped with one of the
following: (A) a DC motor with a power down box, (B)
an AC J box, (C) a DC motor without a power down
box (FIGURE 13). NOTE: operate only one (1) remote
control at a time. Operating two (2) remote controls at
the same time will momentarily block both rf signals
and prevent both controls from functioning.
REMOTE
CONTROL 1
REMOTE
CONTROL 2
BASE 1
BASE 2
STEP 3
Repeat Step 1 and Step 2 with remote control 2.
STEP 4 (BASE 2)
(A) DC motor with a power down box: press the learn
button on the power down box for 1 second.
(B or C) AC Jbox or DC motor without power down
box: unplug the adjustable base electrical power
cord. Wait 30 seconds, then plug the cord back into
the power source.
STEP 5
On remote control 1, simultaneously press and hold
the foot up and tv position buttons (FIGURE 14).
The transmission indicator light will fl ash slowly and
then fl ash rapidly to indicate programming mode.
Continue to hold for 5 seconds and then release the
buttons.
STEP 6
Repeat Step 4 and Step 5 with remote control 2.
Two remote controls are now programmed to operate
two bases.
FIGURE 13: Power down box, AC J box and DC motor.
LEARN
BUTTON
POWER
DOWN BOX
AC J BOX
POWER DOWN
BOX (NOT
MOUNTED TO
BASE FRAME)
AC J BOX
(MOUNTED
TO BOTTOM
SIDE OF BASE
FRAME)
LEARN
BUTTON
DC MOTOR-NO
POWER DOWN
BOX
DC MOTOR
(MOUNTED TO
BOTTOM SIDE OF
BASE FRAME)
A
B
C
STEP 1 (BASE 1)
(A) DC motor with a power down box: press the learn
button on the power down box for 1 second.
(B or C) AC Jbox or DC motor without power down
box: unplug the adjustable base electrical power
cord. Wait 30 seconds, then plug the cord back into
the power source.
STEP 2
On remote control 1, simultaneously press and hold
the foot up and tv position buttons (FIGURE 14).
The transmission indicator light will fl ash slowly and
then fl ash rapidly to indicate programming mode.
Continue to hold for 5 seconds and then release the
buttons.
FOOT UP
BUTTON
TV POSITION
BUTTON
TRANSMISSION
INDICATOR
LIGHT
FIGURE 14
Designer Series
™
99301294
7
INSTALLATION
For installation and setup, complete the following procedures, in the order indicated below
and on the following pages:
MATTRESS
RETAINER
(1 per base)
STEP 1
Before discarding any packing materials,
check the adjustable base shipping carton
and verify the following items are
included:
• (1) Mattress Retainer
• (4) Bed Legs
• (2) Headboard Bracket Assemblies
• (1) Headboard Bracket Hardware Kit
(blister card)
• (1) Remote Control
• (1) Owners Manual
• (1) Warranty Activation Card
• (1) Quick Setup Guide
LEG
(4 pieces)
REMOTE CONTROL
HEADBOARD BRACKET ASSEMBLIES - HARDWARE
(4 bracket pieces, hardware blister card)
(2) Bracket Weldments
(2) Flange Weldments
Blister Card
OWNERS MANUAL
WARRANTY
ACTIVATION CARD
QUICK SETUP GUIDE
5/16-18 Threads