Leggett & Platt Designer Series Owner's Manual - page 12
Designer Series
™
99301294
12
3 inches MAX
.
FIGURE 6: Headboard cross member location must not exceed 3 inches
(76.2mm) from the top of the mattress.
HEADBOARD BRACKET INSTALLATION
INSTALLATION
FAILURE TO FOLLOW HEADBOARD BRACKET
INSTALLATION INSTRUCTIONS MAY CAUSE
HEADBOARD BRACKET INTERFERENCE WITH
BASE FOAM DURING BED OPERATION. BASE
FOAM OR BASE COVER DAMAGE COULD
RESULT.
NOTE
IN ORDER TO AVOID A PERSON OR PET BEING CAUGHT
IN THE SPACE REFERENCED BELOW WHILE THE BASE IS
IN MOTION, THE BOTTOM OF THE HEADBOARD CROSS
MEMBER MUST BE POSITIONED SO THAT THERE IS
NO MORE THAN 3 INCHES (76.2mm) BETWEEN THE
HEADBOARD AND THE TOP OF THE MATTRESS (FIGURE
6). DO NOT EXCEED 3 INCHES (76.2mm). FAILURE TO
FOLLOW THIS INSTRUCTION COULD RESULT IN SERIOUS
PERSONAL INJURY OR DEATH.
Designer Series
™
99301294
17
MR2T8-TVZG FUNCTION
NOTE
REMOTE CONTROL REQUIRES FOUR (4) AAA SIZE BATTERIES. TO CONSERVE
BATTERY LIFE, THE TRANSMITTER TURNS OFF ALL FUNCTIONS WHEN ANY BUTTON
IS PRESSED FOR MORE THAN 50 SECONDS.
MEMORY BUTTON
Press to capture any position and/or
function of the base as a programmed
position. Press the custom button to
adjust the base to the programmed
position.
To Program Memory Position:
1. Adjust the base to any desired position
and/or massage/wave combination.
2. Press the memory button and then the
custom button to save selection.
TRANSMISSION INDICATOR LIGHT
Verifi es a button is being pressed and
data is being sent to the base.
FOOT MASSAGE BUTTONS
To activate the foot massage, press
and release the increase button.
Adjust massage intensity by pressing
and holding the increase or decrease
button. To turn off, press and hold the
decrease button until the massage
turns off.
HEAD MASSAGE BUTTONS
To activate the head massage, press
and release the increase button.
Adjust massage intensity by pressing
and holding the increase or decrease
button. To turn off, press and hold the
decrease button until the massage
turns off.
HEAD UP/DOWN BUTTONS
Press and hold to raise or lower the
head section.
FOOT UP/DOWN BUTTONS
Press and hold to raise or lower
the foot section.
TV POSITION BUTTON
Press to adjust the base to the
preprogrammed tv viewing position to
maximize comfort and entertainment.
This position is reprogrammable using
the memory button. To reprogram,
adjust base to desired position, press
the memory button, then press the tv
position button. The position is now
saved.
ZERO GRAVITY BUTTON
Press to adjust the base to the
preprogrammed reclined position for
optimum weight distribution allowing
total comfort and relaxation. This
position is reprogrammable using the
memory button. To reprogram, adjust
base to desired position, press the
memory button, then press the zero
gravity button. The position is now
saved.
FLAT BUTTON
Press to adjust the base to the
level position.
CUSTOM BUTTON
Press to adjust the base to position
programmed using the memory button.
WAVE LOW BUTTON
Press and hold—after the wave has
been activated—to decrease wave
speed. To turn wave off, press and
hold until wave stops.
WAVE HIGH BUTTON
After the head and/or foot massager/s
have been activated and the desired
intensity has been achieved, press to
turn the wave on. Press and hold to
increase wave speed.