Loewe Individual 32 Compose Sound LED Operating Instructions Manual - page 23
23 -
english
The selection options for the aerials depend on the
receiver units installed or upgraded at the factory (see
also page 137).
Depending on which antenna(s) was (were) selected, the
appropriate settings are called later during the routine.
OK proceed.
Select desired languages and alternative
languages for subtitles and audio for DVB
programmes (see page 55).
Set up audio commentary for the visually
impaired (see page 39).
OK Proceed.
Accept Logical Channel Number no / yes.
In various countries, digital stations (DVB-T, DVB-C,
DVB-S) are transmitted with a preset channel
number per station, known as “Logical Channel
Numbers“ – “LCN“.
If you indicate yes here, the specified programme
numbers will be adopted as station memory loca-
tions and the stations of the preferred signal
sources sorted by LCN. There may be gaps in the
numbering of the station list depending on the LCN.
OK Proceed.
Depending on which antennas (DVB-T, DVB-C, DVB-S)
were selected, the appropriate settings appear
below.
Selecting
antennas
(continued)
Subtitle and
audio
languages
(DVB)
Logical
Channel
Number
Settings
Encrypted
stations
Search
method
Supply voltage
Setting options for DVB-T reception:
If you have not selected a DVB-T antenna in the antenna
selection: Continue with setting options for DVB-C recep-
tion on page 24.
Select and adapt settings for DVB-T reception.
You can state whether coded stations are to be searched
for in the search/update.
Select
yes
to save all found
scrambled stations. However, these stations can only
be received in connection with a CA module and the
appropriate Smart Card.
Handling of the CA module is
described on page 57.
If a CA module with a SmartCard is already plugged in for
the station search, all the stations which this module can
descramble are also saved when no is preset.
If you want to run the station search independently of
the channel grid, select frequency search for the search
method.
OK Proceed.
Select supply voltage no / yes.
Use a DVB-T antenna that requires a supply voltage
(active antenna) and which is not already supplied
via a power adapter, then select yes (5V) for the
antenna’s power supply.
How to align your DVB-T antenna is described on
page 29.
OK Proceed.
OK
no
yes
INITIAL INSTALLATION
Logical Channel Number
Accept Logical Channel Number
Proceed
Back
OK
OK
INITIAL INSTALLATION
Subtitle and audio languages (DVB)
Favoured
subtitle
language
English
...
Alternative
subtitle
language
German
Favoured
audio
language
English
Alternative
audio
language
German
Audio
commentary
off
Proceed
Back
OK
Initial installation
OK
INITIAL INSTALLATION (DVB-T)
Scrambled stations no
yes
Search
method
Channel
search
Proceed
OK
yes (5V)
INITIAL INSTALLATION (DVB-T)
Antenna
Supply voltage
no (0V)
Proceed
Back
OK