Loewe Individual 32 Compose Sound LED Operating Instructions Manual - page 8

- 8

english

For your own safety and to prevent unnecessary damage to your device, 

read and comply with the following safety instructions:

Proper use and environmental conditions

This TV set is designed exclusively for reception and reproduction of 

video and audio signals and is designed for living rooms or office facilities, 

and should not be operated in rooms with high humidity, such as a 

bathroom, or sauna, or where there is a high concentration of dust (e.g. 

workshops). The manufacturer‘s warranty is only valid for use in the specified 

permissible environment.

If the set is used outdoors ensure that it is protected against moisture 

(rain, splashing water, or dew). High humidity and dust concentrations 

cause leak currents in the device, which can cause a shock hazard if the 

device is touched, or a fire.

If you have brought the set into a 

warm environment from the cold, 

then wait for about 1 hour before 

switching it on to avoid formation of 

condensation.

Do not place any objects filled with 

liquids on top of the appliance. Pro-

tect the appliance against dripping 

and splashing water.

Candles or naked flames must be kept 

away from the appliance at all times 

to prevent it from catching fire.

Never place the TV set in a position where it is exposed to vibrations. This 

can lead to material overload.

Transporting

Only transport the device in vertical position. Grasp the device on the 

upper and lower edges of the housing. 

If the set has to be put down during packing/unpacking, place the TV 

set with the entire front surface lying flat on a soft underlay such as a 

blanket or the felt from the packing material. 

The LCD screen is made of glass or plastic and can break if not handled 

properly.

Always wear rubber gloves to carry the TV set if the LCD screen is dam-

aged and liquid crystal might be leaking out. In the case of skin contact 

immediately wash thoroughly with water.

Power supply

The wrong voltage can damage the set.     This equipment must only be 

connected to a mains power supply which has the same voltage and 

frequency as that specified on the rating plate; use the mains cable 

provided. The mains plug of the TV set must be easily accessible so that 

the device can be disconnected from the mains at any time. When you 

unplug the mains plug, do not pull on the cable rather pull on the plug 

housing. The cable in the mains plug could be damaged and cause a 

short circuit the next time it is plugged in.

Lay out the mains cable in such a manner that it cannot be damaged. 

The mains cable must not be kinked or laid over sharp edges, stepped 

on or exposed to chemicals; The latter also applies for the entire equip-

ment. A mains cable with damaged insulation can cause electrical shock 

and is a fire hazard.

Air circulation and high temperatures

The vent slots on the rear panel of the set must always be kept free. 

Please do not place newspapers or cloths on/over the TV. 

Ensure that there is at least 10 

cm free space on the sides and 

above the set for air circulation, 

if the set is placed in a cabinet 

or on a shelf.

  Like any electronic device, your 

TV set requires air for cooling. 

Obstruction of the air circula-

tion can cause fires. 

The set is suitable for different installation solutions. See the instructions 

for assembly for the different installation solutions. Stand the TV set with 

the table or floor stand only on a level, sturdy, horizontal base. Particu-

larly ensure that the set does not protrude to the front when placed in 

or on pieces of furniture. The TV set may only be operated horizontally, 

the vertical tilt must not be more than 10 degrees maximum. The TV set 

must never be operated on edge, lying on the ground or hanging from 

the ceiling.

Set up the device where it is not exposed to direct 

sunlight and where it 

is not exposed to additional warming through heating elements.

 Prevent metal items, needles, paper clips, liquids, wax, or similar items, 

from getting into the interior of the device through the vent slots in the 

rear panel. Such objects can cause short circuits in the set, which could 

possibly cause a fire.

If something should get into the interior of the set then immediately 

unplug the mains plug of the device and contact customer service for 

more information.

 For your  safety

10 cm

10 cm

10 cm