Loewe Individual 32 Compose Sound LED Operating Instructions Manual - page 40

- 40

english

TV stations

Various options for managing stations are available via the TV menu. For 

example the description for TV stations. For radio stations the same applies, 

except that the Radio menu is called in Radio mode (see also page 50).

➠  Station management is not possible if a programmed timer recording 

is still pending.

➠  If at least one station is locked the access code must be entered before 

Search/Update (see Parental lock on page 54).

  Search/update stations –  Search wizard

In the search/update with the search wizard, new stations are searched 

for which have not yet been stored. 

➠  You have to repeat the initial installation (see page 

22) and automatically search for new ones if you 

want to delete all the existing stations and automati-

cally search for new ones. 

MENU: Call TV menu.

  Select  Settings,

  go to the menu line below.

  Select  Stations,

  go to the menu line below.

  Select  Search wizard,

  go to the menu line below.

In the upper info text the current search settings will now 

be displayed:

If you want to change these search settings:

  Select  Change search settings,

  OKwizard prompts search settings.

If you agree with these settings:

  Select  Start search/update,

  OKstart search.

Red button: Abort current search/update.

Explanations of some search settings:

Select the country for country-specific defaults and

station sorting.

Select antenna/cable (analogue), DVB-T, DVB-C or DVB-S 

(1

here depending on which signal source you want to search 

for new stations.

A configuration of DVB-T and DVB-S 

(1

 antennas can also be 

called by the green button (see also page 23 and 24).

➠  Calling up the DVB antenna configuration causes the 

Change search settings dialogue to be quit. You must 

call up the dialogue again after finishing the configu-

ration.

With selection of set location the conventional TV 

standard/colour standard is the default. This should only 

be changed if stations with other standards are to be 

searched.

You can state whether coded stations are to be searched 

for in the search/update. 

Select yes then coded stations 

are also searched for. However, these stations can only 

be received in connection with a CA module and the ap-

propriate Smart Card.

 Ask your dealer which Smart Card 

you need to receive certain stations. Handling of the CA 

module is described on page 57.

If you want to run the station search independently of 

the channel grid, select frequency search for the search 

method.

With the selection of set location the conventional set-

tings will be preset. Only change this if you know other 

symbol rates and modulation types or if you have to 

specify the network ID for your cable network (informa-

tion available from your cable network provider).

If you want to run the station search independently of 

the channel grid, select frequency search for the search 

method.

If you want to run the station search independently of 

the channel grid, select frequency search for the search 

method.

The symbol rate is specified by the satellite provider and 

normally does not need to be adjusted.

Start search/update

SEARCH WIZARD

Your TV carries out the update of the station list (search for new stations; delete 

stations no longer broadcast) with the following settings:

Location 

of 

TV 

set 

       United 

Kingdom

Signal 

source 

         DVB-C

TV MENU

Settings

Station

Search wizard

Change search settings

OK

Managing stations

(1 

Equipment and upgrade options, see page 137.

Set location

Signal source

Antenna/cable:

TV/colour 

standard

 Encrypted 

stations

DVB-T

Search method

DVB-C

Settings

DVB-S

Settings