Magnacoustics Genesis ULTRA Installation And Operation Manual - page 10

Magnacoustics Inc™ © 3/2010 rev – j                                                                  10 | 

System Parts List - continued

13:   CB3 - 10ft. DB9 to Male AMP Cable (Links Breakout Box to Genesis Ultra module.) 

14:  CB4- 3ft DB25 to DB25 Cable (links Breakout Box to AutoVoice board.)    

15:   CB5- 6ft stereo 3.5mm (links audio from the Stereo to Genesis Ultra module.) 

16:  CB6- 6ft 4 conductor cables (links the speaker terminals on the Stereo to speaker 

terminals on the Genesis Ultra module Not used with JVC UX-GN6 After May 2009) 

17:   CB7- 6ft 3.5mm to IR Emitter (connects to Genesis Ultra module and sticks over IR 

receiver on the Stereo prior to JVC UX-GN6)  6ft 3.5mm to 3.5mm Remote Control Link 

(Used with JVC UX-GN6 After May 2009) 

18:  CB8- 6ft AC Adapter Cable (connects the AC Outlet to the Switched, Voltage Selectable, 

and Fused AC Receptacle on the rear of Genesis Ultra module.) 

19:  AutoVoice Breakout Box (intercom integration box.) 

20:   DB9 RF Filter (attaches to penetration panel.) 

21:  DB9 RF Filter adapter plate (to be used on MRIs that do not have a spare DB9 slot.) 

22:   Technologist Control Unit (System Remote Control.) 

23:  Gradient noise sensing Mic (with 10 ft. cable for AGC.) 

24:   (5) Zip Ties and 5 mounting pads to dress cables. 

25:   Stereo remote control. 

26:   Intercom Mic. 

27:  Genesis Ultra Module.