Magnacoustics Genesis ULTRA Installation And Operation Manual - page 14
Magnacoustics Inc™ © 3/2010 rev – j 14 |
Genesis ULTRA Installation and Connections
- continued
36: Press the green Power Button on the TCU a self-test will complete and the system should
power up in Tuner mode. (It may be necessary to adjust the FM antenna to get better
reception. Please keep in mind that if the MRI is located in the basement or if most of the
transmitting Radio stations are separated by the Scan Room RF Shielding, some form of
auxiliary or external antenna might be required.
37: After making sure the Stereo is playing ok (with Tuner, iPod or CD selected). Depress the
Green
VOL NORM button and go into the Scan Room to ensure there is music playing
from the Headsets. (If you have help depress the Green
Mic button speak into the
supplied Mic (make sure the Mic mute switch is off) to ensure intercom operation.
Auto Gain Calibration Procedure
38: In order to calibrate the
Microprocessor for AUTO GAIN Function it will be necessary to
program the Ambient and Full Scan SPL levels, the please follow this procedure;
a. Depress the Blue
PROG MODE button once.
b. Depress the
MUSIC VOL- buttonto toggle down till 11. Ambient MIC Set is highlighted.
c. Depress the
INPUT/ENTER button once and then again allowing the Auto Gain Mic to
capture the SPL in the room with the scanner idle.
d. Depress the
MUSIC VOL- once to highlight 12. SCAN MIC Level Set depress the
INPUT/ENTER once.
e. Set up a Phantom and start the Scanner for and average scan (Full Scan Level).
f. Depress the
INPUT/ENTER one more time to capture the SPL in the room with the
scanner active.
g. Depress the Blue
PROG MODE once (which will store the two extremes) and let the
Microprocessor calculate how much Auto Gain in necessary.
CAUTION: Please do not connect any external Antenna or Audio input to the stereo without the
proper isolation. We use the Scan Room Shielding as our ground reference. Any auxiliary
connection to the stereo might not have the same ground potential causing a 60 cycle hum from
the speakers or patient headset. This difference in ground potential my also cause system
damage.
1. Radio Shack Ground Loop Isolator Catalog #: 270-054 with the proper phono to 3.5mm
stereo adapter Radio Shack Catalog #: 274-883 and xx adapter or equivalent must be used.
2. A 75 to 300 ohm adapter in series with the any external antenna source must be used.