Magnacoustics Genesis ULTRA Installation And Operation Manual - Caution
Magnacoustics Inc™ © 3/2010 rev – j 11 |
Genesis ULTRA Installation and Connections
Refer to Stereo Manual for Illustrations and for identification of controls.
CAUTION
Ensure that AC cords from the Stereo and Genesis Ultra module are not connected to
power source until all connections are completed. Also ensure that the power entry
receptacle is set up for your voltage 110 / 220
Use Page 15 & 16 for J# Illustrations
1: Place Genesis Ultra module and as close to operator’s console as possible, the floor is
permissible. Place the Stereo on the work station or as close as possible.
2: Place Technologist Control Unit on operator’s console and connect cable from
Technologist Control Unit to
J8 on the rear of Genesis Ultra module.
3: Place the speakers on the floor beside the console or other suitable location out of the
way.
4: Pre JVC UX-GN6, connect speaker cables to the lower 4 terminals of
SPK 1 on the
Genesis Ultra module. Observe polarity. With JVC UX-GN6 connect the speaker cables
to back of stereo; “CB6” is not used.
5: (Skip to step 6 if using JVC UX-GN6 Stereo after May 2009 Serial #181335ML or higher)
Connect one side of cable “CB6” 6ft 4-conductor cable to the speaker terminals on the
back of the Stereo Red and Black to Left Red and Black, Green and White to Right Black
and Red respectively, the other side of cable “CB6” to the upper terminals of
SPK1 on the
rear of Genesis Ultra module.
Follow the same colors and polarity as you did with the
Stereo.
6: Connect one cable “CB5’ 6ft stereo 3.5mm to
J1 on the rear of Genesis Ultra module, and
the other side to
J1 on the rear of the Stereo.
7: a. If JVC UX-GN6 is used after May 2009 (Serial #181335ML or higher) Connect one side
of CB7 to
J7 on Genesis Ultra module the other side to J7 on the rear of the stereo.
b. If prior to May 2009 (Serial #181334 or lower); Connect cable “CB7” 6ft 3.5mm to IR
Emitter plug to the
J7 on the rear of Genesis Ultra module. Remove the protective
paper from the back of the red IR transmitter and place it over the IR detector that is
located about 1/4” to the right of “CD2” label on the JVC MHC Stereo.
Caution: CB5 and CB6 look alike, please do not misconnect! (CB5 to J1 and CB6 to J7)
8: Place the Intercom Mic on the Operators Console and plug the cable into
J4 on the rear of
Genesis Ultra module. Make sure the MIC slide switch on stalk is turned on.
If you are installing the Intercom Integration Kit follow steps 9 – 13, if not go to step 14
9: Connect the round AMP end of “CB3” 10ft. DB9 to Male AMP Cable to
J6 on the rear of
Genesis Ultra module.
11: Connect the DB9 end of “CB3” to the DB9 on the AutoVoice Breakout Box.