Magnacoustics Genesis ULTRA Installation And Operation Manual - page 4
MagnaLink™ Headset & MagnaPlug™ Instructions
The MagnaLink™ System provides the patient with 30dB of attenuation (NRR) tested per ANSI
standard and complies with GE Healthcare’s MR Safety Guide Operator Manual, Revision 7
requirements.
Because your MRI can produce sound pressure levels that may cause hearing damage, GE
Healthcare requires that the Technologist ensure a proper fit of all hearing protection devices.
Please refer to the detailed instructions below. This procedure will take less than 1 minute to
accomplish, assuming the headsets and consumables are readily available and in close proximity
to the gantry.
Magnacoustics Inc™ © 3/2010 rev - j
4|
|
1. There are two sizes of
MagnaPlugs available:
MagnaPlug .75” X .50” for
average size ear canals
MagnaPlug Mini .75” X .38”
for smaller than average size
ear canals
2.
The MagnaLink™ “Yoke” will
provide a small amount of
tension to maintain the
MagnaLink to MagnaPlug to
patient ear canal connection.
3. The MagnaLink couplers
rotate to facilitate alignment
of MagnaPlugs with the
patient’s ear canals.
4. Please identify what size
MagnaPlug is required for the
patient and then insert them
into the MagnaLink couplers.
5.
Hold the MagnaLink headset
in your hands. Using your
thumbs and first fingers gently
start rolling,
gradually
increasing pressure.
6.
Roll until you reach the
smallest diameter possible.
Avoid pinching.