Magnacoustics Genesis ULTRA Installation And Operation Manual - page 6
Magnacoustics Inc™ © 3/2010 rev – j 6 |
Technologist Control Unit Operation
Terminology: TCU = Technologist Control Unit
1: To turn Genesis MRI Music
ON from TCU push the Green Power button (located on the top right
corner).
2: To adjust Technologist’s
Speaker Music Level depress the Green TECH VOL+ and the Red
VOL– (located to the left of the Power button) for UP and Down respectively. The Stereo will
show the level. To
Mute the Technologist’s Speakers depress the Violet TECH MUTE button
(located under the Red
VOL- button). The “ON” will flash on the mid right side of the display in the
MUTE box.
3: On power up the microprocessor sets
VOL, Mic, and AVC levelfor patients wherever it was left
when the system was turned off. The number equals the percentage of volume and the horizontal
bar gives a quick visual representation.
4: Depressing the Green
Mic button (located on bottom left corner) will allow you to override music
and talk to the patients. Level can be adjusted buy depressing Green
Mic VOL+, or the Red
VOL-, for UP and Down respectively. A good starting point is 50. When Mic button is depressed
you will see “Mic” on the lower left “
MODE” box of the display.
5: When the
AVC (intercom integration) input has triggered from depressing the Mic button on
your GE Intercom (providing the intercom integration kit was installed) the Display will show
AVC
in the lower left “MODE” box, and the music to the patient will be interrupted. The AVC level and
the console intercom level will control the level to the patients (it’s a good idea adjust the AVC
and, leave the console set the same for a Patient without Headsets.) A good starting point is 50
but no two MRIs are the same.
6: Depressing the Red
PAT OVERRIDE button (located above the Mic button) will toggle thru
locking out the patient from adjusting the
VOL, SEL, VOL SEL, or OFF. This will also be
displayed on the lower right
“PAT OVR” box.
7: We recommend getting in the habit of depressing the
Red PAT MUTE button (located above PAT
OVERRIDE button) after each patient (this way when you are setting up a new patient they will be
able to hear you, if the music is on they probably can’t.)
8: Depressing the Green
VOL NORM button (located above VOL OFF button) will raise Volume for
the Patients to 20. This preset is a good starting point and can be adjusted in program mode
described in
step 14.
9: Depressing Red
MUSIC VOL- button (located above the VOL NORM button) will lower Volume
for the Patients, and depressing the Green
MUSIC VOL+ (located above the MUSIC VOL-
button) will raise Volume for the Patients.
10: The Genesis has a feature called
AUTO GAIN this provides the ability to automatically adjust
volume level of music to Patients dependent on the amount gradient noise being created by MRI.