Magnacoustics Genesis ULTRA Installation And Operation Manual - page 2
Magnacoustics Inc™ © 3/2010 rev – j 2
|
Important Safety Instructions
CAUTION
This installation manual is intended for Qualified Field Service Engineers. If you are not
thoroughly familiar with ALL MRI SAFETY REQUIREMENTS, Magnacoustics recommends that
you DO NOT ATTEMPT THIS INSTALLATION!
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with a dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatuses that produce
heat.
9) Do not defeat the safety purpose of the polarized or grounding‐type plug. A polarized plug has two blades with
one wider than the other. A grounding‐type plug has two blades and a third grounding prong. The wide blade or
the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician
for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and
the point where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with a cart, stand, bracket, or table specified by the manufacturer, or sold with the apparatus. When
a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip‐over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged
in any way, such as power‐supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
15) Warning ‐ this equipment is not waterproof. To prevent a fire or shock hazard, do not place any container
filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or
moisture.
Warning: This equipment has been certified to comply with the limits for a Class B computing device, pursuant to
Subpart J of Part 15 of FCC Rules. Only peripherals certified to comply with the Class B limits may be attached to
this equipment. Operation with non‐certified peripherals is likely to result in interference. This equipment
generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with
the manufacturer’s instructions, may cause interference. It has been type tested and found to comply with the
limits for a Class B computing device in accordance with the specifications in Subpart J of Part 15 of FCC Rules,
which are designed to provide reasonable protection against such interference.
Caution: The power switch on this unit will not completely shut off all power from the AC outlet. Since the power
cord serves as the main disconnect device for the unit, you will need to unplug it from the AC outlet to shut down
all the power. Therefore, make sure the unit has been installed so that the power cord can be easily unplugged
from the AC outlet in case of an accident. To avoid fire hazard, the power cord should also be unplugged from the
AC outlet when left unused for a long period of time (for example if facility will not be in
operation for a few
weeks)