NAD T765 Owner's Manual - page 13
ABOUT THE ON-SCREEN DISPLAY (OSD)
The T 765 receiver employs a simple, self-explanatory system of on-screen display “menus” that will
appear on the connected video monitor/TV. These are required during the setup process (and are
useful in day-to-day operation), so be sure to connect the monitor/TV before proceeding with setup.
DISPLAY THE OSD
Press either or ENTER buttons of the HTR 3 remote control or front panel to display the T 765’s Main
Menu on your video monitor/TV. If the OSD does not appear, check your MONITOR OUT connections.
NAVIGATING THE OSD AND MAKING CHANGES
To navigate through the OSD menu options, please do the following using the HTR 3 or corresponding
front panel buttons:
1. Press to select a menu item. Use
keys or in some cases, ENTER, to move up or down the
Menu selections. Repeatedly press to advance or go further into sub-menus of a desired menu
item.
2. Use
keys to set or change the parameter value (setting) of a menu item.
3. Press to save the settings or changes done on the current menu or sub-menu. Pressing will
also return the user to the previous menu or exit from a particular menu.
MAIN MENU
The Main Menu contains the menu options for ‘Listening Mode,’ ‘DSP Options,’ ‘Tone Controls,’ ’Zone
Controls’ and access to ‘Setup Menu.’
To navigate through these Main Menu options and their sub-menu selections, please refer to and
follow the directions stated in the sections ‘Display the OSD’ and ‘Navigating the OSD and Making
Changes.’
NOTE
The individual configurations set forth at ‘Listening Mode,’ ‘DSP Options’ and ‘Tone Controls’ are
carried over whenever they are enabled during A/V Preset setting. Please see the section ‘AV Presets’
for reference.
LISTENING MODE
The T 765 offers distinct listening modes, tailored for different types of recording or program material.
With a two-channel (Stereo) source, the following listening modes can be selected:
STEREO
All output is directed to the front left/right channels. Low frequencies are directed to the subwoofer
if one is present in the Speaker settings. Select ‘Stereo’ when you wish to listen to a stereo (or
monaural) production, such as music CD or FM broadcast, without surround enhancement. Stereo
recordings whether in PCM/digital or analog form and whether surround-encoded or not encoded,
are reproduced as recorded. Multi-channel digital recordings (Dolby Digital and DTS) are reproduced in
“Stereo Downmix” mode via the front left/right channels only as Lt/Rt (left/right-total) signals.
DIRECT
The analog or digital sources are automatically played in their native formats. All the source’s audio
channels are reproduced directly. This mode recreates the original sound most faithfully thereby
producing outstandingly high quality audio.
PRO LOGIC
Two-channel recordings, whether stereo or surround-encoded, are reproduced with Dolby Pro
Logic surround processing, yielding output to front left/right, center and discrete left/right surround
channels (assuming these are present in the current ‘Speaker Configuration’). The surround channel is
monophonic, but it is reproduced in both surround speakers.
OPERATION
USING THE T 765 – MAIN MENU
13
ENGLISH