NAD T765 Owner's Manual - page 41

MACRO COMMANDS

A “macro” command is a series of two or more remote codes issued automatically from a single 

keypress. You might use a macro to automate a simple command sequence, such as, “Turn on the DVD 

player and then press PLAY”. Or you might compose an elaborate macro to power up an entire system, 

select a source, choose a Listening Mode, and begin playback—again, all from a single keypress. The 

HTR 3 can store one macro on each of its function keys (these exclude the Device Selector keys).

NOTE

Macros are independent of the currently selected device.

RECORDING MACROS

To record a macro, simultaneously press-and-hold for 3 seconds both the [MACRO] key and the HTR 3 

function key to which you wish to assign the macro, until the status LED turns green. The macro 

button will also light up. 

Press the sequence of function keys to be recorded into the macro, being sure to first press the 

requisite Device Selector key for each function (you may switch devices while recording the macro as 

many times as necessary), allowing you to create macro containing commands from more than one 

Device Selector “page.” 

When you have finished entering the desired command sequence, press [MACRO] again

to store the macro; the Learn LED and [MACRO] key illumination will turn off.

NOTE

Each macro can store a maximum of 64 command steps. If you exceed this number, the macro will 

be stored automatically after the 64th command is added.

Example: Record a Macro to the [0] key to Turn on the T 765, Select “Input 1” (Source 1), and 

Commence Playback of connected Source 1 device (as in DVD player):

•  On the HTR 3, simultaneously press-and-hold [MACRO] and [0] (numeric zero); the Learn LED turns 

steady green.

•  Press [AMP]; press [ON]; press [1] (“Input or Source 1”); press [DVD]; press [ ] (Play) - the Learn LED 

blinks as each step is added.

•  Press [MACRO] again to exit the macro-record mode.

To clear a macro, perform the above steps without entering any functions.

EXECUTING MACROS

To execute a macro, press and release [MACRO]; its key illumination lights for 5 seconds. While it 

remains lit, press an HTR 3 key to which a macro has previously been stored. 

The corresponding macro will run; as each step executes, its “parent” Device Selector’s key flashes lights 

briefly; when execution is finished, the [MACRO] key illumination goes out. Pressing any other HTR 3 

key while a macro is executing will abort the macro. Remember that you must hold the HTR 3 so that 

its infrared emitter can activate the target components.

NOTE

When a macro executes, a 1 second delay is automatically inserted between its commands. If 

you need more than a 1 second delay between particular commands—for example, to permit a 

component to power up completely—you can record “empty” steps into the macro by changing 

Device Selector “pages” without entering actual command functions.

BUTTON ILLUMINATION TIMEOUT

The HTR 3’s key-illumination can be set to remain lit for 0-9 seconds. The default value is 2 seconds. To 

set the illumination timeout, simultaneously press-and-hold for 3 seconds both the HTR 3’s [DISP] and 

the [0-9] key, with the digit corresponding to the desired timeout duration; the Learn LED will flash 

twice to confirm the new setting. When set to zero, the illumination will not turn on at all.

NOTE

Key illumination is the biggest drain on the HTR 3’s batteries. A short key-illumination timeout will 

extend battery life appreciably; turning it off altogether (set it to 0 seconds) will lengthen it still 

further.

OPERATION

USING THE HTR 3 REMOTE CONTROL

41

ENGLISH