NAD T765 Owner's Manual - page 17

SETUP MENU

The Setup Menu allows one to customize the operation of the T 765 to the ancillary equipment used 

in one’s specific AV system. Unless your system exactly matches the factory defaults as shown in the 

accompanying Quick Start Guide, you will need to use the setup menu to configure the inputs of the T 765. 

At Setup Menu, the following are configurable – Source Setup, Speaker Setup, Zone Setup, Amplifier 

Setup, Trigger Setup, Listening Mode Setup, Display Setup and A/V Presets.

To access and navigate through Setup Menu and its sub-menu selections, please refer to and follow 

the directions stated in the sections ‘Display the OSD’ and ‘Navigating the OSD and Making Changes.’

SOURCE SETUP 

From Setup Menu, pressing   will direct you to the Source Setup menu wherein you could adjust 

allocate or change the settings of the following – Source Setup (Normal View), Source Setup (Table 

View) and iPod Setup.

SOURCE SETUP (NORMAL VIEW)

The Source Setup (Normal View) menu makes it possible to set, allocate or change the following settings.

SOURCE

The T 765 is equipped with ten configurable Sources. The settings for each Source are dependent on 

the configurations set forth in the parameters for that particular Source window. 

To change or toggle through the Sources, scroll to ‘Source’, press   button and then ENTER or 

 to 

move up or down the Source selections.

NOTE

Source 5 is defaulted to iPod. For Source 5 to be changed and allocated for other inputs, go to ‘iPod 

Setup’ menu under the ‘Source Setup’ menu.  At iPod Setup menu, set ‘Enabled’ to ‘No’ – you can 

now assign Source 5 to other inputs or settings as desired.

ENABLED

One can enable/disable a Source via this option. This is particularly useful if only few Sources are used 

and one directly selects the Source from the front panel, bypassing unused sources.

To enable or disable a particular Source, scroll to ‘Enabled’ and press 

 keys to select ‘Yes’ or ‘No’.

NAME 

A new Name maybe assigned to a Source label. For example, if your DVD player is attached to 

‘Source 1’, it is possible to rename ‘Source 1’ to ‘DVD Player.’ 

In order to rename the Source label, scroll to ‘Name’ and press   to go the character. Then, press 

to pick through the alphanumeric selections. 

Press 

 to move to the next character and at the same time save the changes done on the current 

character. The name can be as long as twelve characters.

The new Name will be shown in the VFD as well as on the OSD.

OPERATION

USING THE T 765 – SETUP MENU

17

ENGLISH