NAD T765 Owner's Manual - page 38

NAD IPD 2

The NAD IPD 2 has its own remote control - the DR 1.  For you to control the 

NAD IPD 2 using the DR 1, you have to go to “iPod Setup” menu (please refer 

to the item about “iPod Setup” under the “USING THE T 765 – SETUP MENU” 

segment of OPERATION section) and then set “Auto Connect” to “No”.  With 

this setting, you can then use the DR 1 to control your iPod player docked 

in the NAD IPD 2.  Note that if you set “Auto Connect” to “No” while at Source 

5, you have to change source and then return to Source 5 for the changed 

setting to take effect. 

When using the DR 1 to command your iPod player docked in the NAD IPD 

2, you have to refer to your iPod player’s own display screen to make full use 

of its feature; there is no OSD at this condition. However, any time you press 

HTR 3’s [   ] or front panel’s [TUNE 

 ], the “Menu Select” OSD comes up.  

If you select “iPod Menu” at this “Menu Select” option, the NAD IPD 2 gets 

manually connected.  The control of the NAD IPD 2 will then again be done 

through the T 765 using the applicable front panel control buttons or HTR 3 

buttons while referring to the OSD; the NAD IPD 2 will not respond to any 

DR 1 commands at this stage.

In addition to the above commands common to the DR 1, below are the 

descriptions of the other DR 1 control buttons.

LIGHT  

Press [LIGHT] to turn ON the backlight of your iPod player if it is at idle 

mode.

MENU 

Press [MENU] to return to previous option or menu selection

ENTER

Press [ENTER] to select an option or start playback.

Ꭷ (REPEAT) 

Toggle to initiate repeat mode as follows - repeat one song, repeat all songs 

or cancel repeat mode 

Ꭶ (RANDOM) 

Toggle to initiate playback in random order. There are three random modes 

– Shuffle Song, Shuffle Album or Shuffle Off.

TO VIEW VIDEOS OR PHOTOS LOADED IN YOUR iPod

Videos or photos uploaded in your iPod can be viewed directly via the 

T 765. The following are the steps

1  Make sure that the [TV Out] setting of your iPod’s Video Settings menu 

is at [On] mode and appropriate [TV Signal] is chosen.

2  Video or photo file selections and playback procedures are managed 

directly from your iPod player and not through the T 765.  You must exit 

completely from the T 765’s Setup Menu or Menu Select OSD for you 

to be able to navigate through your iPod player’s video or photo menu 

options. A more direct way is by going to the ‘iPod Setup’ menu and set 

‘Enabled’ to [No].

3  With the NAD IPD’s S-VIDEO OUT and AUDIO OUT ports connected to 

the T 765’s AUDIO/VIDEO 5 input or to any other assignable input, you 

can now directly enjoy via T 765 your video or photo file selections as 

uploaded in your iPod. Make sure that you select the correct ‘Source 

Number’ of the T 765.

NOTE

For other navigation functions, please refer to your iPod player’s owner’s 

manual. Depending on the iPod player model, some other functions 

maybe controlled using the applicable T 765 navigation controls.

iPod is a trademark of Apple, Inc., registered in the U.S. and other countries.

OPERATION

USING THE T 765 – AM/FM/DB/iPod

38

ENGLISH