NAD T765 Owner's Manual - page 43
LOADING CODE-LIBRARIES
The HTR 3 can store a different library of default NAD codes for each of its Device Selector “pages.”
If the original default library does not control your NAD CD player, tape deck, DVD player, or other
component, follow the procedure below to change the code-library.
Begin by ensuring that the component you wish the HTR 3 to control is plugged in and powered-up
(“on,” not merely in standby). To enter the HTR 3s Library Mode, simultaneously press-and-hold for 3
seconds both the desired Device Selector key and the [AVPS] key, until the Learn LED turns green.
While keeping the HTR 3 pointed toward the component, enter the first appropriate three-digit code-
library number from the table below. Press [OFF]. If the component turns off, press [ENTER] to accept
that code-library number and exit the Library Mode. If the component does not turn off, enter the next
three-digit code-library number from the table.
When you enter the correct number the component will turn off; press [ENTER] to accept that code
library number and exit the Library Mode.
LIBRARY CODE
NAD PRODUCT DESCRIPTION
LIBRARY CODE
NAD PRODUCT DESCRIPTION
100
Receiver/Processor (Discrete ON/OFF)
300
Tuner
101
Receiver/Processor (Toggle ON/OFF)
301
L75, L76 Tuner
102
S170
302
L70 Tuner
103
L75
303
L53 Tuner
104
Second Zone Commands (Zone 2)
304
L73 Tuner
3112
Zone 3
305
C425
4112
Zone 4
306
C445
105
L70
307
Txx5 Series Tuner
106
L76
400
Tape Deck B
107
118
401
TAPE Deck A
108
L53
500
TV 280
109
L73
501
MR13
110
Stereo Receiver / Amplifier
502
MR20
111
Stereo Second Zone
503
PMR45
112
Txx5 Series
600
T535, T562, T585, M55
200
CD Player
601
T550, L55
201
CD Player (old)
602
T512, T531, T532, T571, T572
202
5170, 5240, 5340
603
L70, L73 DVD
203
5325
604
L56
204
5060
605
T513, T514, T515, T517, T524, T533, T534
205
M5
606
L53 DVD
SEARCH MODE
If none of the codes from the table, when entered, turns on the component, and if you are quite sure
you have followed the above procedure completely and carefully, you may want to try the “search”
method as follows:
Enter Library Mode by simultaneously pressing-and-holding for 3 seconds both the desired Device
Selector key and the [AVPS] key, until the Learn LED turns green. Now press-and-hold the HTR 3’s [ ] or
[ ]) key; the remote will step through all the available codes at a rate of approximately 1 per second.
When the component turns off, immediately release the cursor key; press [ENTER] to accept that code-
library and exit the Library Mode. Try a few commands; should you prove to have stepped past the
needed code-library, re-enter the Library Mode and use the cursor key to step back to it.
NOTE
It is possible that search mode will find code-libraries that operate, at least partially, some other
brand (non-NAD) components. You may certainly exploit such capabilities as you find them.
However, since we can only ensure the completeness or accuracy of NAD code-libraries, we cannot
support the HTR 3’s operation with other-brand components.
OPERATION
USING THE HTR 3 REMOTE CONTROL
43
ENGLISH