NAD T765 Owner's Manual - page 20

SOURCE SETUP (TABLE VIEW)

The Source Setup (Table View) reflects the settings made in the Source Setup (Normal View) menu. All 

the Source settings are summarized and displayed in tabulated form in the Source Setup (Table View).

Navigating through the Source Setup (Table View) via a combination of   and then 

 keys, one will 

have the benefit of directly changing the settings for ‘Audio, Video, Preset, Trigger and Source Name’ 

without going back to the Source Setup (Normal View) menu. 

iPod SETUP

The iPod Setup menu allows you to preset the following associated settings when iPod is the selected 

source: 

 Enabled 

: Select ‘Yes’ to enable iPod as a Source or ‘No’ to disable it.

Auto Connect : Select ‘Yes’ to automatically enable and connect the iPod player docked in the 

linked NAD iPod docking station when Source 5 (the default iPod source allocation in the T 765) is 

selected. Select ‘No’ if you do not want for the iPod connection automatically connected. 

 Menu 

Timeout 

: Set the time for the OSD to revert to the ‘Now Playing’ display when the iPod 

menu has been left idle (no scrolling or navigation being done) for the specified time out time.  For 

the ‘Now Playing’ OSD to be shown, there should be a song paused or being played before going 

to the iPod menu. You can set the ‘Menu Timeout’ between the range 5s to 60s at 5s increments.  If 

you do not want for the menu to timeout, select ‘Off.’

SPEAKER SETUP

After connecting all ancillary sources and other combinations, the Speaker Setup menu will guide 

you on how to manage and setup your speakers in order to achieve optimum sound acoustics in your 

listening environment. 

The following are the Speaker Setup Menu sections.

AUDYSSEY SETUP

It has been shown that many, if not most, surround sound systems are not accurately configured and setup. 

This requires special knowledge and instrumentation that the average person probably doesn’t possess. 

The T 765 has the capability to automatically setup your own unique Home Theatre’s speaker system. 

This is achievable through the T 765’s Audyssey Setup feature along with the sophisticated digital 

electronics built into your unit.

The installation of your new T 765 is greatly simplified by Audyssey Setup with the end result of 

delivering the best quality sound possible given the type of speakers you have as well as your listening 

room’s dimensions.

Audyssey Setup takes up only a fraction of time to run compared with setting up your speakers 

manually and then achieve results that rival other expensive test and setup measuring devices. 

The following measurements are performed:

• Detection 

: Speaker configuration is detected including the number of surround speakers and 

whether a subwoofer and center channel is connected.

• Size 

: T 765 crossover is set based on each channel’s signal handling capability and the subwoofer 

crossover is automatically set.

• Level 

: SPL of each speaker is matched within 1dB at the microphone position.

• Distance 

: is accurately set to within 1 foot (30 centimeters) of the microphone for each speaker 

position.

• Polarity 

: the setup program will detect and notify the user if any speakers are connected 

improperly. Incorrect polarity can ruin the illusion of realism offered by surround sound.

This is a one-time setup, unless speakers are moved or changed, in which case Audyssey Setup should 

be performed again. 

OPERATION

USING THE T 765 – SETUP MENU

20

ENGLISH