Nautilus BE STRONG E916 Service Manual - page 23
2
Nautilus® Commerical Series Elliptical Service Manual
Table2–5.console
Problem
Potentialcauses
Remedy
The console does not power up
(dead).
The console is not plugged into the
main cable.
• Plug the main cable into the
console.
The main cable is not plugged into
the power board.
• Plug the main cable into the
power board.
A screw has pierced through the
CHR/ Remote Button cable.
• Remove the CHR cables from
the console. If the console
powers up, the screw is the
problem. Replace the cable.
A screw has pierced through the
main cable, or the main cable is
pinched.
• Connect the power board to the
console with the main cable on
the outside of machine. If the
console powers up, a screw or
pinched cable is the problem.
Replace the cable, and make
sure not to crimp the cable
when replacing it.
The battery is dead.
• Charge the battery using the
suppied charger.
• Replace the battery.
The speed sensor is too far from
the speed disk.
• Readjust the gap.
The console is bad.
• Replace the console.
The console powers up but locks up
or flashes on and off.
A screw has pierced the CHR/
Remote Button cable.
• Remove the CHR cables from
console. If the console powers
up, a screw is the problem.
Replace the cable.
A screw has pierced the main
cable, or the main cable is pinched.
• Connect the power board to the
console with the main cable on
the outside of the machine. If
the console powers up, a screw
or pinched cable is the problem.
Replace the cable, and make
sure not crimp the cable when
replacing it.
The console is bad.
• Replace the console.
The battery is below 6.0V.
• Refer to the electronic
troubleshooting flowchart. Verify
that the battery is bad with no
secondary problem occurring.
commonElectricalProblemsandPotentialcauses