Nautilus BE STRONG E916 Service Manual - 7 ! 2 . ) . '
Nautilus® Commerical Series Elliptical Service Manual
mechanical Procedures
E916 and EV916 Procedures
BElT TENSION ADjUSTMENT
Tools needed:
• Ratchet
• Cordless drill
• 9/16 Socket
• 7/16 Socket
• phillips bit
• Belt gauge (Kent Moore BT-33-73-F or equivalent)
Step 1: Remove the outer covers of the frame.
Model: E916 -
1-1 Remove attaching screws to Drivetrain Cover. See
Figure 1-1. Set the screws aside for Step 10.
1-2 place left Footlink pod in upswing position (see
Figure 1-2).
1-3 Remove the attaching screws to the left Drivetrain
Cover, and carefully move the cover over the pod
toward the front of the machine (see Figure 1-3).
1-4 Repeat steps 1-2 and 1-3 on the Right Drivetrain
Cover.
Model: EV916 -
1-1 Remove attaching screws to Drivetrain Cover (see
Figure 1-1).
1-2 place left Footlink pod in upswing position (see
Figure 1-2).
1-3 Remove the attaching screws to the left Rear Back
Cover and set aside.
1-4 Repeat steps 1-2 and 1-3 on the Right Rear Back
Cover.
Step 2: Remove attaching screws to Assembly, Resistor and
Bracket (see Figure 1-4).
This section of the Service Manual provides instructions for servicing the EV916 and E916 ellipticals. The first
segment contains procedures that apply to both elliptical models. The second segment contains instructions
specific to the E916 elliptical, and the third contains instructions specific to the EV916 elliptical. For part number
information, please refer to the separate documents for warranty parts lists and exploded drawings.
figure 1-1
figure 1-2
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
To avoid damage to the unit or
electrical shock, unplug the e/eV9
machine before disassembling the
console or removing covers.
figure 1-3