Nautilus BE STRONG E916 Service Manual - 7 ! 2 . ) . '
40
mechanical Procedures
Step 20: Tighten the Alternator Adjustment Bolt (see Figure
2-7) and watch the gauge until it reads 50-60 pounds.
Note: The belt will stretch slightly after a short
period of normal operation. The tension should
not go below 45 pounds.
Step 21: Reattach the Resistor Assembly and all covers se-
curely.
Step 22: Retest the machine and adjust as needed.
UppER pIVOT ShAFT lUBRICATION
Tools needed:
• (Two) 3/4 inch wrenches
• Snap Ring pliers
• long Shaft phillips Bit
• Cordless Drill
• Rust Inhibitor cloth (Corwipe
®
500 - p/N 40040-001)
• petroleum based lubricant (lubriplate made by Fiske
Brothers Refining Company)
On the LEFT SIDE of the machine:
Step 1: Remove the Swing Arm Assembly from the Mast,
exposing the Upper pivot Shaft.
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
To avoid damage to the unit or
electrical shock, unplug the e/eV9
machine before disassembling the
console or removing covers.