Nautilus BE STRONG E916 Service Manual - page 38
8
mechanical Procedures
Step 3: loosen Bracket Bolts on right and left side (see Figure
2-5).
Step 4: loosen Adjustment Bolts on right and left side (see
Figure 2-6).
Step 5: loosen Alternator Belt adjustment nut and push
Alternator downward to loosen the belt (see Figure
2-7). Remove the loosened Alternator Belt from the
Flywheel grooves.
Step 6: Remove the old Flywheel using a 15/16 socket, and
replace with new smaller mass Flywheel. See Figure
2-8.
Step 7: Using a 1/8 Allen bit, untighten the Set Screws holding
the Intermediate pulley in place (see Figure 2-9).
Step 8: From the right side, tap the Shaft back through the
bracket and spacer, into the pulley. Remove the Drive
Belt and Alternator Belt from the Intermediate pulley
grooves.
Step 9: Remove the pillow Block bolts on both left and right
side of the Drive pulley with a 9/16 socket and wrench
(see Figure 2-10).
Step 10: lift the Drive Belt off the grooves and over the pillow
Block to remove from the Drive pulley.
figure 2-6
figure 2-5
Bracket Bolts
Adjustment Bolts
figure 2-7
Alternator
Adjustment Bolt
Alternator
Adjustment Bolt
Figure 8
Figure 9
Figure 10