Nautilus BE STRONG E916 Service Manual - page 24
Other manuals for BE STRONG E916:
Service Manual, Specifications, Assembly Manual, Assembly Manual, Owner's Manual
of
50
24
No Display
Short TP7 to TP10
on the Power
Board.
Does
the Console
display
light?
Unplug J6 and
check that the
voltage between
the two contacts
on the plug is 3 –
3.5VAC while
rotating the crank
arms.
Is
the voltage
good?
Check that the gap
in the Speed
Sensor is no
greater than 1/16
of an inch.
Is the gap
good?
Replace the
Battery.
End
Readjust the
Speed Sensor
gap.
Check that the
voltage between
TP12 (GND) and
pin 1 of J3 on the
Power Board
reads 6VDC when
the pedals move.
Is
the voltage
good?
Replace the Power
Board.
Replace the
Speed Sensor.
End
No
Yes
No
Yes
No
Yes
End
Next Page
No
Yes
TroubleshootingFlowcharts