NEC ElectraElite IPK Installation And Maintenance Manual - page 18
Electra Elite IPK
Document Revision 1
SPE Hardware, Installation, and Maintenance Manual
1 - 5
___________________________________________________________________________________
___________________________________________________________________________________
2.3
Installation
Only one SPE(M)-U( ) ETU can be installed in the system. The SPE(M)-U( )
ETU can be installed in the following slots: AP, S1 or S2. When the modem is
used the SPE(M)-U( ) ETU must be installed in the S1 or S2 slot.
2.4
Switch Settings
Table 1-2 Switch Settings
Switch
Setting
Description
SW 1
On
COM – D acting as a DCE (Default)
Off
COM – D Acting as a DTE
SW 2
On
COM – C acting as a DCE (Default)
Off
COM – C Acting as a DTE
SW 3
NA
Reset the SPE(M)-U( ) ETU
SW 4-1
On
Not Used
Off
Not Used (Default)
SW 4-2
On
Restores Card to Factory Defaults
Off
Save Settings (Default)
SW 4-3
On
Not Used
Off
Not Used (Default)
SW 4-4
On
Not Used
Off
Not Used (Default)
SW 4-5
On
Not Used
Off
Not Used (Default)
SW 4-6
On
Not Used
Off
Not Used (Default)
SW 4-7
On
Enables Debug through COM 1 of the KSU
Off
Debug is disabled through COM 1 of KSU (Default)
SW 4-8
On
MIFM Mode Only ( Emulates MIFM; SPE features are
disabled)
Off
SPE Mode (Default)