NEC ElectraElite IPK Installation And Maintenance Manual - page 24
SPE Hardware, Installation, and Maintenance Manual
3 - 1
___________________________________________________________________________________
___________________________________________________________________________________
Chapter 3
SPE(M)-U( ) ETU Configuration
S
ECTION
1
C
ONFIGURING
SPE(M)-U( ) ETU
Set the DIP switch SW 4-8 to the desired settings on the SPE(M)-U ( ). Refer to
2.4
Switch Settings on page 1-5
.
Place the SPE(M)-U( ) ETU Ethernet port in the Electra Elite IPK KSU in the
appropriate slot of the KSU. Refer to
2.3 Installation on page 1-5
for appropriate slots
that the SPE card can be installed in.
Connect the Ethernet cable to the Ethernet connector on the SPE(M)-U( ) ETU. This
is the bottom most connector on the SPE(M)-U( ) ETU. Refer to
Section 2 Hardware
on page 1-3
. When installed for the first time, the SPE(M)-U( ) ETU, comes up with
factory-set default parameters as shown in
Table 3-1 Factory Network Settings
.
In this configuration, the Ethernet port cannot be used in any randomly given
environment, and its parameters must be redefined before the SPE(M)-U( ) ETU can
work in your environment. The required parameters can be set by using the web
browser and connecting to the default IP Address (192.168.1.100) in the browser
navigation address bar. Refer to
Appendix A Web-Based Setup and Configuration on
page A-1
for a detailed description of this configuration utility.
On = MIFM Mode Only
Off = SPE Mode (Default)
Table 3-1 Factory Network Settings
IP Address
192.168.1.100
Subnet Mask
255.255.255.0
Default Gateway
192.168.1.1