NEC ElectraElite IPK Installation And Maintenance Manual - page 54
Electra Elite IPK
Document Revision 1
SPE Hardware, Installation, and Maintenance Manual
C - 9
___________________________________________________________________________________
___________________________________________________________________________________
Proceed to Downloading/Uploading the system data as if you were directly connected
to the system via Serial or Modem connection.
S
ECTION
3
R
ETURNING
THE
SPE(M)-U( ) ETU
TO
F
ACTORY
D
EFAULT
C
ONFIGURATION
This section allows an SPE(M)-U( ) ETU to return to factory default settings.
Step 1.
Remove the SPE(M)-U( ) ETU from the system.
Step 2.
Set DIP switch SW 4-2 to the following:
SW4 – 2 to (ON = Restores card to factory defaults)
Step 3.
Reinsert the SPE(M)-U( ) ETU into the system. Once the LEDs have lit
according to the boot procedure, remove the SPE ETU from the system.
Figure C-8 Screen Showing SAT is Connected