NEC ElectraElite IPK Installation And Maintenance Manual - page 41
B - 4
SPE Application Software
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 1
Electra Elite IPK
S
ECTION
4
C
ONFIGURATION
S
CREEN
The SPE Application is rather simple and contains only three screens. When the
application is started, the initial screen that comes up is the Configuration screen.
Virtual Serial Port Mapping.
Select the Virtual COM ports that are needed in the
current loaded configuration. The mapping to the applications and/or physical
SPE serial ports is listed beside the respective Virtual COM port.
Profile Name.
This name allows the user to give a descriptive name to the site file.
The actual file stored can be the same name or a different name.
Connection Method.
Only one connection method mapping can be selected at any
one time: Serial, TCP/IP, or Modem. If the Serial method is chosen, then the
user needs to select the physical COM port on the laptop that will be
connected to the KTS chassis. If the TCP/IP method is chosen, then the
technician must enter the IP Address of the SPE module into the fields shown.
Figure B-2 Configuration Screen