NEC ElectraElite IPK Installation And Maintenance Manual - page 48
Electra Elite IPK
Document Revision 1
SPE Hardware, Installation, and Maintenance Manual
C - 3
___________________________________________________________________________________
___________________________________________________________________________________
S
ECTION
2
C
ONFIGURING
SAT T
ECHNICIAN
OR
E
ND
-U
SER
TO
C
OMMUNICATE
D
IRECTLY
TO
SPE(M)-U10
VIA
E
THERNET
This is an example of how to configure SAT to directly communicate with the SPE
card over the Ethernet. This example assumes that the SPE(M)-U( ) ETU has been
configured with the appropriate IP address information.
In order for SAT to communicate with the SPE(M)-U( ) ETU directly, the version of
SAT Technician or End-User must be version 2.51 or higher to properly support this
type of connection.
Table C-1 Comparison of ETUs
Board
Connector
Type
Default Connection
Voice Mail (VMS, VMS+, VMP,
FMS, FMS+, CMS, CMS+)
DB9M
DTE
38,400 N81
ACD+
DB9M
DTE
38,400 N81
CTI
DB9M
DTE
38,400 N81
BSU, CCH, PRT, BRT
DB9M
DCE
38,400 N81
Figure C-2 SAT Version 2.51