NEC SL2100 Quick Install Manual - page 8
Install the IP7WW-082U-B1 Card
Quick Install Guide
– SL2100 Terminals Type B rev 1.0
8
2- Install the IP7WW-082U-B1 Card
The SL2100 chassis does not have any cards pre-installed, you install the extension interface card of your
choice.
! Ensure the SL2100 is powered off before removing/installing any card.
You may also have a trunk daughter card to mount onto the IP7WW-082U-B1 card, refer to the Quick Install
Guide for the trunk card type for installation details.
The following trunk daughter cards may be mounted
IP7WW-3COIDB-C1
3 Analogue trunks
IP7WW-2BRIDB-C1
2 ISDN BRI circuits (4 trunk channels)
IP7WW-1PRIDB-C1
1 ISDN PRI circuit (30 trunk channels)
Each IP7WW-082U-B1 card can have one daughter card mounted.
If you are connecting a doorphone unit then you must set the hardware links before mounting a trunk daughter
card and installing the card into the chassis, refer to the Doorphone section later in this guide.
Note
– Slot 4 does not support digital extensions, an IP7WW-082U-B1 card can be installed but will only support
analogue extensions, any trunk daughter card is supported in slot 4.
Remove the plastic knockout from the slot on the front of the SL2100 chassis.
Note
– the knockout can not be replaced once removed; there are no blanking covers available, be sure to
remove the correct knockout.
Insert the interface card into the SL2100 universal slot, ensure the card slides into the guide rails and tighten the
two screws to secure the card.