1. DL manuals
  2. NEC
  3. Voicemail
  4. Univerge SV9100
  5. Configuration manual

NEC Univerge SV9100 Configuration manual

Summary of Univerge SV9100

  • Page 2: 9100

    ® sv 9100 sip trunking service configuration guide for idt/net2phone nda-31841 issue 1.0

  • Page 4: Nec C

    Sip trunking service configuration guide - 3 idt/net2phone issue 1.0 nec c orporation of a merica reserves the right to change the specifications , functions , or features at any time without notice . Nec c orporation of a merica has prepared this document for use by its employees and customers . T ...

  • Page 5

    Issue 1.0 idt/net2phone 4 table of contents.

  • Page 6

    Sip trunking service configuration guide i table of contents section 1 nec sv9100 and idt/net2phone setup guide ................................................. 1 1.1 this guide and related documents ........................................................... 1 1.2 idt/net2phone account ..............

  • Page 7

    Issue 1.0 idt/net2phone 4 table of contents 3.11 ip trunk calling party number setup ....................................................... 19 3.12 ip trunk (sip) calling party number setup for extensions ...................... 20 3.13 did (tn to ext map) ..............................................

  • Page 8

    Sip trunking service configuration guide i list of figures and tables table 1 installation worksheet ............................................................................................ 4 figure 1 blade configuration ..............................................................................

  • Page 9

    Issue 1.0 idt/net2phone iv list of figures and tables table 4 troubleshooting guide ........................................................................................ 28.

  • Page 10: Nec Sv9100

    Sip trunking service configuration guide 1 configuring nec sv9100 with idt/ net2phone sip trunking service s ection 1 nec sv9100 and idt/n et 2p hone s etup g uide 1.1 this guide and related documents this guide was created to assist knowledgeable vendors with configuring the nec sv9100 communicatio...

  • Page 11

    Issue 1.0 idt/net2phone 2 sip trunking service configuration guide 1.4 requirements with the sv9100, a voip gateway daughter board is required in addition to licensing for ip (sip) trunks. A minimum of four ip (sip) trunks are required due to the nec communications server infrastructure setup. The s...

  • Page 12: Nec Pbx C

    Idt/net2phone issue 1.0 sip trunking service configuration guide 3 m secondary sip server for failover not supported. M network-based call forward, call transfer, sequential ringing, and simultaneous ringing not supported. M the interop tested was completed with registration sip trunks, and sip prof...

  • Page 13

    Issue 1.0 idt/net2phone 4 sip trunking service configuration guide table 1 installation worksheet wan side: internet access type and speed: wan ip address: wan subnet mask: wan gateway ip address: lan side: lan ip address for siparator or edgemarc: lan subnet mask: lan ip address for sv9100: vlan id...

  • Page 14: Sv9100 P

    Idt/net2phone issue 1.0 sip trunking service configuration guide 5 s ection 3 sv9100 p rogramming when using idt/net2phone as your sip trunking service provider, the following programs must be changed for sip trunking service. When using pcpro or webpro for programming, enabling an option may be a c...

  • Page 15

    Issue 1.0 idt/net2phone 6 sip trunking service configuration guide figure 2 ipl dsp resource selection 10-19-01 : voip dsp resource selection specify the operating mode for the dsp resources (0=common use (extensions and trunks), 1=ip extensions only, 2=sip trunks only, 3=networking, 4=netlink, 5=bl...

  • Page 16

    Idt/net2phone issue 1.0 sip trunking service configuration guide 7 figure 3 ip trunk availability 10-68-1 : ip trunk availability – ip trunk availability assign the trunk type as sip. 10-68-2 : ip trunk availability – start port assign the starting port for the sip trunks. 10-68-3 : ip trunk availab...

  • Page 17

    Issue 1.0 idt/net2phone 8 sip trunking service configuration guide 3.2 gcd-cp10 network setup values shown are for example purposes only. Your actual ip values will be determined by your local lan administrator. Figure 4 gcd-cp10 network setup 10-12-1 : gcd-cp10 network setup – ip address set the la...

  • Page 18

    Idt/net2phone issue 1.0 sip trunking service configuration guide 9 if a router or firewall is placed between the sip trunk provider and sv9100, you must also set the following programs: . All routing and forwarding is done by the starbox lite router, so napt should not be needed in the sv9100. 10-12...

  • Page 19

    Issue 1.0 idt/net2phone 10 sip trunking service configuration guide 10-54-2 : blade license setup – quantity assign the quantity of voip dsp channel licenses (5103) . The license quantity can be found on feature activation page. 3.4 ipl dsp basic setup values shown are for example purposes only. You...

  • Page 20

    Idt/net2phone issue 1.0 sip trunking service configuration guide 13 table 2 port table (udp) iple licensed channels begin port end port 12 10020 10043 24 10020 10067 48 10020 10115 64 10020 10147 128 10020 10275 256 10020 10531 table 3 router forwarding (gateway table) iple ip address rtp port rtcp ...

  • Page 21

    Issue 1.0 idt/net2phone 12 sip trunking service configuration guide 3.5 sip system information setup values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 7 sip system information setup 10-28-1 : sip system information setup – domain na...

  • Page 22

    Idt/net2phone issue 1.0 sip trunking service configuration guide 13 3.6 sip server information setup values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 8 sip server information setup.

  • Page 23

    Issue 1.0 idt/net2phone 14 sip trunking service configuration guide 10-29-01 : sip server information setup – outbound default proxy enable (1) the sip outbound proxy. . If entries are made in program 10-29-xx for a sip server and the sip server is then removed or not used, the entries in program 10...

  • Page 24

    Idt/net2phone issue 1.0 sip trunking service configuration guide 15 3.7 sip trunk registration information values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 9 sip trunk registration information 10-36-1 : sip trunk registration infor...

  • Page 25

    Issue 1.0 idt/net2phone 16 sip trunking service configuration guide 3.8 ip system interconnection setup values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 10 ip system interconnection setup 10-23-1 : system interconnection enable int...

  • Page 26

    Idt/net2phone issue 1.0 sip trunking service configuration guide 17 3.9 calling party information (trunk) caller id - in the invite message there are two fields that can have caller id. One field is the “sip from address” and the other field is “sip display info”. If both of these fields are left bl...

  • Page 27

    Issue 1.0 idt/net2phone 18 sip trunking service configuration guide 3.10 class of service options (outgoing call service) values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 11 class of service options (outgoing call service) 20-08-13...

  • Page 28

    Idt/net2phone issue 1.0 sip trunking service configuration guide 19 3.11 ip trunk calling party number setup figure 12 ip trunk (h.323/sip) calling party number setup for trunks 21-17-01: calling party number setup for trunks on a per trunk basis this populates the “sip display info” field. If a sta...

  • Page 29

    Issue 1.0 idt/net2phone 20 sip trunking service configuration guide 3.12 ip trunk (sip) calling party number setup for extensions values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 13 trunk (sip) calling party number setup for extens...

  • Page 30

    Idt/net2phone issue 1.0 sip trunking service configuration guide 21 3.13 did (tn to ext map) values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 14 incoming call trunk setup 22-02-01 : incoming call trunk setup define the sip trunks a...

  • Page 31

    Issue 1.0 idt/net2phone 22 sip trunking service configuration guide 3.14 sip trunk codec setup values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 15 sip trunk codec information basic setup 84-13-28 : sip trunk codec setup – audio cap...

  • Page 32

    Idt/net2phone issue 1.0 sip trunking service configuration guide 23 3.15 tos setup values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 16 tos setup 84-10-01 : tos setup – tos mode for the rtp/rtcp (protocol type 5) and sip trunk (prot...

  • Page 33

    Issue 1.0 idt/net2phone 24 sip trunking service configuration guide 3.16 sip trunk basic setup values shown are for example purposes only. Your actual values will be determined by your implementation team. Figure 17 sip trunk basic setup 84-14-11 : sip trunk basic setup – url/to header setting infor...

  • Page 34

    Idt/net2phone issue 1.0 sip trunking service configuration guide 25 figure 18 fax over ip setup 84-33-01: fax over ip setup – fax relay mode set this program to enable for sip trunk for fax testing. (fax is not tested for this testing) . This setting is not applicable for this carrier test..

  • Page 35

    Issue 1.0 idt/net2phone 26 sip trunking service configuration guide figure 19 voipdb dtmf setup - dtmf relay mode 84-34-01: voipdb dtmf setup – dtmf relay mode set this to rfc2833 for sip trunk..

  • Page 36

    Idt/net2phone issue 1.0 sip trunking service configuration guide 27 s ection 4 i nitial t esting and t roubleshooting to confirm that the system is correctly set, perform the following tests: . If you run into an issue with any of these tests, refer to table 4 troubleshooting guide . Test an outgoin...

  • Page 37

    Issue 1.0 idt/net2phone 28 sip trunking service configuration guide table 4 troubleshooting guide issue cause remedy no calls in/out m router configuration m check router configuration m nec configuration m check nec configuration m unqualified ip address m note wan ip address and contact provider n...