Oki FAX 5250 Handbook - page 150

150

OKIFAX 5250

|

06 MONITOR VOLUME

This function sets the volume for telephone line

monitoring during dialing.

Available settings are LOW (default), HIGH, and OFF.

07 BUZZER VOLUME

This function sets the volume of the various tones your fax

machine emits during operation. Available settings are

LOW, MIDDLE (default), and HIGH.

08 CLOSED NETWORK

This function allows you to program your fax machine to

refuse to communicate with locations whose telephone

numbers have not been programmed into your One Touch

keys or Auto Dial locations. Using this function, you can

set up a closed network of fax machines. Refer to the

“Security, Rejecting Unsolicited (Junk) Fax Messages”

section of this handbook. If you do not want your fax

machine to transmit faxes to or receive faxes from

locations outside your network, select T/R. If you only

want your fax machine to refuse to receive faxes from

outside your network, select RX.

Available settings are OFF (default), T/R, and RX.

04 IMAGE IN MCF

When a message confirmation of a memory transmission

is printed, this function adds a portion of the first page of

the document that was sent. This feature makes it easier to

identify a fax, but it may present security problems if you

are sending sensitive documents.

Available settings are ON (default) and OFF.

05 SENDER ID

This function controls the printing of your fax machine’s

Sender ID on the faxes you send. Refer to the

“Programming Required Information, Fax Identification”

section of this handbook for details. When turned on, the

Sender ID will be printed on each page slightly outside the

image area of your document.

The default setting is ON.

!

In order to meet FCC requirements, you must have

thisvfeature set to ON and have a valid Sender ID

programmed in your fax machine.