Oki FAX 5250 Handbook - page 56

56

OKIFAX 5250

|

7 Using a separate telephone line, dial the number assigned to

the fax machine within 90 seconds.

If you don’t have access to a second line, have someone

else make the call for you. When your fax machine begins

to ring, it automatically detects and remembers its assigned

ring pattern. Be sure to let it ring until either 

RESULT=OK

or 

RESULT=NG displays. When the fax machine has

successfully finished programming its ring pattern, the

display shows 

RESULT=OK.

!

Occasionally, your fax machine may not be able to

detect its ring pattern on the first try. If this happens,

the display shows RESULT=NG. Follow the

instructions again from Step 6.

8 Press the Yes 

§ key to confirm your selection.

9 Press the Select Function key to finish.

Remote Receive: User Function 17

This function lets you use an attached phone to tell your fax

machine to switch from telephone to fax mode so it can

receive an incoming fax. Use the keypad of an external

telephone to enter the remote receive number you have

programmed into your fax machine.

In addition, if your fax machine is in TAD mode, a caller can

enter the programmed remote receive number after leaving a

voice message. This enables the fax machine to receive a fax

from the caller. Refer to the “Answering Mode, Using Your

Fax with an Answering Machine [TAD]” section of this

handbook.

Available settings are OFF (default), 00, 11, 22, 33, 44, 55,

66, 77, 88, 99, **, and ##.