P&E Microcomputer Systems XPC560P EVB User Manual - page 14
of
53
10
xPC560P EVB User Manual
Figure 3-1: Power Supply circuitry schematic
3.2
LEDs
There are four user LEDs available on the xPC56XXMB. All LEDs are active
low.
J7 – LEDs Enable
Controls whether the LEDs on the xPC56XXMB motherboard are connected
to I/O pins of the processor. The jumpers can be removed and wires can be
used to connect each LED to any processor I/O pin, if desired. Please note
that although the schematics indicate that the processor I/O pins are eMIOSx,
those are not the I/O pins for the xPC560P EVB. The table below has the
correct pins listed.
Off (default)
Low battery detection is disabled
Jumper Setting
Effect