P&E Microcomputer Systems XPC560P EVB User Manual - page 29
xPC560P EVB User Manual
25
J33 – FlexRay Bus Driver 2 Pull‐up Enable
Controls which pins on the FlexRay Bus Driver are pulled up.
J38 & J39 – FlexRay 2 Terminal Resistor Connection
1+2
The TXD pin on the FlexRay Bus Driver is connected to
the “PD0” pin on the MPC560xP processor.
3+4
The TXEN pin on the FlexRay Bus Driver is connected to
the “PC15” pin on the MPC560xP processor.
5+6
The RXD pin on the FlexRay Bus Driver is connected to
the “PD1” pin on the MPC560xP processor.
Jumper Setting
Effect
1+2
The BGE pin on the FlexRay Bus Driver is pulled up to 5V
3+4
The STBN pin on the FlexRay Bus Driver is pulled up to
5V
5+6
The EN pin on the FlexRay Bus Driver is pulled up to 5V
7+8
The WAKE pin on the FlexRay Bus Driver is pulled up to
5V
Jumper Setting
Effect
On
Terminal resistors connected
Off (default)
Terminal resistors not connected